Global Industrial 293047 Manual Del Usuario página 10

Remote Control Operation Instructions
1. After the ceiling fan has been installed according to the
assembly procedure and connected according to power supply
specifications, perform the remote control and ceiling fan
pairing procedure (refer to the remote control pairing method
below).
2. After the pairing has been completed, you can use the remote
control to turn on/off the ceiling fan, and select speed.
OPERATING INSTRUCTIONS
Remote control pairing procedure:
1 Pairing instructions
(1) Power the fan on and within 60 seconds press the
Off) button on the remote for 5 seconds. The remote will initiate
the pairing process.
(2) For model 293048 & 293049, the fan will response the
remote by three "B" sound and finished the pairing process in
less than 20 seconds.
For model 293047, the fan will response the remote by three
"B" sound and then start automatically, indicating successful
activation of the following pairing and fine tuning process 3 & 4.
(3) During the fine tuning process, the fan rotates clockwise
until it reaches maximum speed and then stops. Then, the fan
rotates counterclockwise until it reaches maximum speed and
then stops.
(4) The pairing and fine tuning process has been completed.
This process takes approximately 3 to 5 minutes.
Note: During the pairing process, pressing any buttons will have
no effect. Normal operation resumes after the pairing process
has been completed.
2 After successful pairing
The fan will operate normally and can be controlled with the
remote control. For any setting on the remote, the Fan will
response by a "B" Sound.
Remote controller can pair with multiple Fans as many as you
wanted. But the Fans can memorize the last two remote
controller paired with them only.
3 Memory function
This fan has a speed memory function in case of power
outages. If the fan operates at maximum speed when it shuts off
in a power outage, it will resume its operation at the maximum
speed when the power comes back on. The memory function
registers the last operating speed.
4 In case of blade replacement
Repeat steps from section 1 above (pairing procedure) after
replacing the fan blades.
5. Direction control
Perss the Direction Control can
change the fan blade rotate direction.
When the fan blade rotates clock-
wise and the air will blow down.
A downward air flow creates a cooling
effect.This allows you to set your air
conditioner on a higher temperature
setting without affecting your comfort.
When the fan blade rotates counter-
clockwise and the air will blow up.
An upward airflow moves warm air off
the ceiling area. This allows you to set
your heating unit on a lower setting
without affecting your comfort.
Industrial DC Ceiling Fan
0
(Power
MAINTAINANCE
Make sure the power is off before maintenance.
1.Because of the fan's natural movement, some connections and
screws may become loose. Check the support connections,
brackets, and blade attachments at least twice a year to make
sure they are secure.
2.Clean the fan periodically to help maintain the appearance. Do
not use water when cleaning. This could damage the motor, or
possibly cause electric shock.
3.Use only a soft brush or lint-free cloth to avoid scratching the
finish.
4.There is no need to oil your fan. The motor has permanently
lubricated bearings.
10
User's Manual