CASSETTE PLAYBACK
CASSETTE PLAYBACK
1. Open the cassette door and insert a tape (see fig. 2).
2. Press the door lightly to shut.
3. To start playback, press 1.
4. Adjust the sound with VOLUME.
• For personal mono sound listening, insert 3.5mm
headphones (preferably type ≥16 ohms) into the p socket.
The built-in speaker will then be disconnected.
5. To fast wind, press 5 or 6.
6. Watch the tape counter display to find the point in the tape
you want to listen to. Press 9 to stop fast winding at the
selected point.
• 5 or 6 also allows you to fast cue or review during
playback. Using the tape counter to monitor passages, hold
down on 5 or 6 and release the key at the passage you
want. Tape playback continues from this point.
• To reset the tape counter display to 000, press the
COUNTER RESET switch.
7. You can also adjust TAPE SPEED to find or listen to
passages during playback. Set TAPE SPEED to:
•
for high speed playback;
• 0 for normal speed playback;
-
•
for low speed playback.
Remember to set TAPE SPEED to 0 for normal playback!
6
8. For brief interruptions, adjust PAUSE ;. To deactivate
pause, slide the switch back again.
9. To stop playback, press 9 and the set is switched off.
• At the end of a tape, the 1 key is automatically released
and the set switched off, unless PAUSE ; has been
activated.
GENERAL INFORMATION ON RECORDING
• This set is not suited for recording on CHROME (IEC II) or
METAL (IEC IV) type cassettes. You should only use
NORMAL type cassettes (IEC type I) on which the tabs have
not been broken.
• Altering the VOLUME and TAPE SPEED controls will not
affect the recording in progress with the exception of when
VOICE ACT is in use and VOLUME is adjusted.
• At the very beginning and end of the tape, no recording will
take place during the 7 seconds when the leader tape
passes the recorder heads.
• Recording is permissible insofar as copyright or other rights
of third parties are not infringed.
RECORDING