RECORDING
• To monitor your recording, connect headphones to p.
4. To start recording, press REC 0.
• The REC indicator lights up.
• You can also start recording immediately during playback.
Press REC 0.
5. For brief interruptions, adjust PAUSE ;. To deactivate
pause, slide the switch back again.
6. To stop recording, press 9 and the set is switched off.
• The REC indicator goes out.
• At the end of a tape, the 1 and REC keys are automatically
released and the set switched off, unless PAUSE ; has
been activated.
7. To check your recording, use the 5 or 6 keys (see
CASSETTE PLAYBACK).
GENERAL INFORMATION
MAINTENANCE (see fig.4)
• Clean the tape heads every month with a cotton bud dipped
in alcohol, or by playing through a cleaning tape.
• Use a soft damp cloth to wipe off dust and dirt. Don't use
benzene or corrosives to clean the set.
• Don't expose the set or cassettes to rain, moisture, sand or
to excessive heat e.g. cars parked in direct sunlight.
• Don't use C-120 tapes.
8
GENERAL INFORMATION
TAKE CARE WHEN USING HEADPHONES
Hearing Safety: Listen at a moderate volume. Use at high
volume can impair your hearing!
Traffic Safety: Do not use headphones while driving or
cycling as you may cause an accident!
ENVIRONMENTAL NOTE
• The packaging has been minimized so that it is easy to
separate into two materials:- cardboard and plastic. Please
observe the local regulations regarding the disposal of
these packaging materials.
• Please inquire about local regulations on how to hand in
your old set for recycling.
This product complies with the radio interference
requirements of the European Community.