Xblitz Spirit 2 Manual Del Usuario página 10

key. Pressing the key switches to the next unit.
06. PRECAUTIONS
1. Do not drop the device or shake it violently.
2. Test results may be inaccurate when battery capacity is low.
3. To ensure the accuracy of the measurement, perform the test 15 minutes
after drinking alcohol.
4. If the device has been left unused for a long time, the first measurement
taken may be inaccurate.
5. If you want to perform multiple tests, wait at least 1 minute between tests.
6. Do not blow tobacco smoke, liquids or pieces of food into the device. This
can permanently damage the sensors and lead to incorrect measurements.
7. If the device is dirty, use a gentle material to wipe it down. Do not use
caustic cleaners or wire or hard cleaning utensils, they could damage the
appliance casing. Do not use caustic cleaners or wire or hard cleaning tools,
as these could damage the appliance.
8. The correlation between breath alcohol content and blood alcohol concen-
tration depends on a number of variables, including environmental factors
(such as wind, humidity, temperature, etc.) as well as the health of the
person being tested.
9. The measurement results from this device do not constitute evidence in
legal terms and cannot be used in court. The driver bears full responsibility
for driving under the influence of alcohol.
10. The result of a test can vary depending on many factors. Getting a given test
result one time does not mean that the result will be the same even a few
minutes later.
11. Do not allow yourself or anyone else to drive after consuming alcohol.
Always use a taxi or other vehicle driven by a sober person when you or
someone else has consumed alcohol.
12. Under normal use, the device needs to be recalibrated approximately every
6 months or after 500 tests performed. For accurate measurement results,
contact your device distributor or service centre and ask them to recalibrate
the device's sensor.
07. FAQ
The following are the messages that may appear on the display and their meaning.
1. Error: Nothing is displayed on the screen.
Possible reason: Incorrectly installed batteries
Solution: Correctly insert the batteries in the device
Possible reason: Batteries close to discharge
Solution: Replace the batteries
Possible cause: Circuit failure
10