Publicidad
Idiomas disponibles
Idiomas disponibles
STORE THE GUITAR
• Do not keep the instrument close to a fire or flame, and keep it on a low, stable surface.
• Do not leave the instrument leaning against the wall, etc., in the vicinity of children.
• Long-term storage in the hard case may have an adverse affect on the guitar. Open the case occasionally to let air circulate
within the case.
• If the instrument is not going to be used for an extended period of time, keep the instrument in a place other than those listed
below.
▪ Locations subject to direct sunlight.
▪ Locations subject to extremely high or low temperatures.
▪ Locations subject to high humidity, dust, or vibration.
▪ During the summer season, temperatures inside of a car can become extremely hot. Do not leave the instrument inside of a
car.
AMPLIFIER
1. Guitar input – Plug in your guitar here.
2. Gain – Adjust the amount of pre-amp gain. High gain setting will supply more distortion
and sustain.
3. Boost – Press to turn boost mode on/off.
4. Volume – Rotate to adjust the amplifier output level.
5. Treble – Rotate to adjust the high (treble) tones.
6. Mid – Rotate to adjust the middle tones.
7. Bass – Rotate to adjust the low (bass) tones.
8. Phones – For connecting stereo headphones.
9. AUX – Connect an audio source (e.g. MP3 player, mobile phone) to play along.
10. Power – Switch the amplifier on/off.
HEIGHT ADJUSTMENT (LOCKING NUT)
1. Remove the 3 hexagonal lock pad screws, exposing the nut base.
2. Loosen the 4 nut base fixing screws.
3. Adjust the height by turning the height adjustment screws. Raise the base by
turning clockwise, lower the base by turning counterclockwise.
NOTE: The guitar has been setup in the best condition in the factory, please avoid the
adjustment unless you have the needed experience. Otherwise, it's suggested to
entrust any adjustment to your dealer.
HEIGHT ADJUSTMENT (BRIDGE)
String height refers to the space between the strings and frets, and has an affect on playability. String height is adjusted with the
bridge and/or the saddle on the bridge. Adjust height by alternately turning the screws little by little on the left and right sides.
Set too high and the instrument is hard to play. Too low results in fret noise. Adjust so that the space between the string and the
last fret measures as follows:
String
Tuning
1
E
2
B
3
G
4
D
5
A
6
E
CHANGING STRINGS
1. Use the supplied hexagonal wrench to loosen the three hexagonal screws.
2. Loosen the individual string locks, again using the supplied hexagonal
wrench.
3. Replace the old strings with new strings.
4. Use the hexagonal wrench to lock each string.
5. After locking, make sure that the fine tuning screws are in the middle of
their range of travel.
4
Height
1.9mm
2.0mm
2.1mm
2.2mm
2.3mm
2.4mm
Publicidad
