Publicidad
Idiomas disponibles
Idiomas disponibles
3. Remove the contents, shelves, shelf mounting
clips, and door storage bins from the locker.
4. Remove all components from the outside of the
connection to the adjoining storage unit (such as
bumpers and chargers).
5. Lay the locker on its back. Use the packaging
6. Remove the two swivel casters that will be nearest
to the adjoining storage unit.
7. Place foam block adjacent to the bottom edge of
the existing MILWAUKEE cabinet.
8. Lock caster wheels on the Locker as unlocked
wheels will cause a tipping hazard.
9. Lift the Locker upright and set on top of the foam
block. Locker should be stationary.
10. Gently roll the existing MILWAUKEE cabinet
directly adjacent to the upright Locker and align
the attachment holes per diagram. This should
Foam block
Remove all
components from
existing storage
unit that interfere
connection to the
locker.
Casters
locked
11. Lock the caster wheels on the existing
MILWAUKEE tool storage cabinet.
12. Connect the locker to the adjoining MILWAUKEE
cabinet using eight bolts (CC) and washers (DD)
through the interior mounting rail slots of the
locker into the adjoining storage unit. Space bolts
evenly across the lower, mid, and upper sections
of the locker as shown for the best connection.
Tighten all bolts securely with a wrench.
Plastic plugs
13. Insert the red plastic plugs into the exposed press
nut holes on the front of the storage unit and
locker. Match the shape of the plug to correspond
to the shape of the hole.
USB Power Outlet
The USB ports on the power outlet can be used to
charge any device that uses less than 2.1A of DC
electrical current.
NOTE: Any device that uses more than 2.1A of DC
electrical current will trip a self-resetting overload and
disable the output.
OPERATION
To avoid injury or property dam-
WARNING
age, do not exceed maximum shelf
capacity. Use care when moving the locker on
incline or rough surface. Locker may tip if weight
is not evenly distributed front to back and side
to side. Place more than half the total load weight
on the bottom shelves when possible.
Locking and Unlocking the Locker
Insert the key. Turn it fully left to lock, or fully right
to unlock. Always remove the key after locking and
unlocking.
Using the Caster Brakes
To lock the swivel casters,
step down on the levers
marked ON. Be sure to lock
all casters to prevent locker
from rolling or swiveling. To
unlock casters, push down
on the levers marked OFF.
6
DD
CC
Publicidad
