Whispbar K421W Instrucciones De Montaje página 7

EN
Fitting Kit
K421W
NOTE: FRONT CROSSBAR ONLY
TYPE A CROSSBARS ONLY
Insert foam into crossbar as shown.
Trim if required.
Use two M5 x 12 mm self tapping screws to
secure the assembly onto the leg.
Do not over tighten.
Fitment
Locate two holes at each position along the
inside of the roof rails.
Place crossbars approximately above
these holes on roof rails.
Ensure back edge of foot sits flush with the
back edge of vehicle roof rail.
7