Pentair MAGICSTREAM Guia De Instalacion página 10

Control Summary (Standard Mode)
Start programming with the LED light engine ON. Change programs and modes by cycling the power ON and OFF
rapidly (1 Sec). Wait 10 seconds between MODE changes.
PROGRAM
/MODE
RESET OFF/ON/OFF/ON/OFF/ON/OFF/ON
SOLENOID
OFF/ON/OFF/ON/OFF/ON
THUMPER
LOCK COLOR
LED LIGHT
COLOR
CHANGE
Sync Mode - Colors will change at about 10sec intervals. In this mode, multiple Laminars will change colors together. If the
solenoid thumper mode is turned on, the thumpers on multiple Laminars will thump together.
Random Mode - Colors will change at about 10sec intervals but in a completely random sequence. In this mode, multiple
Laminars will NOT change colors together. If the solenoid thumper mode is turned on, the thumpers will thump at random
intervals and multiple laminars will NOT thump togheter.
Party Mode - Colors will change randomly and slowly at first, then speed up, until the sequence ends with quick flashes and
strobes. Then the sequence starts again with slow changes. In this mode, multiple Laminars will NOT change colors together.
If the solenoid thumper mode is turned on, the thumpers will thump at random intervals
POWER CYCLE
OFF/ON
OFF/ON/OFF/ON
COLOR CHANGE MODE DESCRIPTION
and multiple laminars will NOT thump together.
DESCRIPTION
Resets Light Engine to
Random mode and turns on
the thumper.
Turns solenoid "thumper" ON
or OFF
Locks on any selected color.
Returns to previous color
change mode.
Switches from one color
change mode to next. After a
Reset, Random mode is
running.
10
INDICATION
Flashes Light 2 times
Flashes Light 4 times
Color is fixed
Sync Mode–1 flash
Random Mode–2 flashes
Party Mode–3 flashes