Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
TROUBLESHOOTING
Problems
Sensor Connector
Door does no operate
Power Supply
Sensor is very dusty or
covered in water drops, etc.
Door operates
Sensitivity too low
intermittently
Detection pattern in the
wrong position
Sensitivity too high
Another sensor is too close by
Door operates by itself
Sensor detects the door
movement
There is a cloth mat in the
monitored area.
Detection pattern too farin
front of the door, detecting
people passingby
The condition of the monitored
area is varying.
Dusty / Dirty / Snow
8 - RIP- Ver. 02
INSTALLATION MANUAL
Cause
Tighten connector or reconnect
Check that the power supply is properly connected.
Clean the sensor (do not use thinner or alcohol to clean sensor)
Turn up sensitivity
Alter the detection pattern by changing sensor angle, dip switch
settings and/or pattern width adjustments
Turn down Sensitivity.
Change the frequency to each sensor.
If the indicator LED is an Orange color, adjust the pattern depth
angle away from the door
Turn the sensor power off and then on again, and allow it 10
seconds.
Adjust the detection pattern - move it closer to the door
The condition of the monitored area can change due to heavy dust or dirty,
heavy snow or footprints being left in fresh snow, this will cause the door
to open sometimes. Set the Presence Timer to a short times.
See Section 6.
Solution
Publicidad
