LawnMaster CLMF2434G Manual De Instrucciones página 29

TROUBLESHOOTING
Mower does not mulch properly.
Poor cutting or motor labours.
Area of cut (battery duration) is
not large enough.
The cutting blade is not rotating
while the garden product is
switched on.
Excessive vibrations/noise.
No charging procedure
possible.
The charge control LEDs do not
light up after inserting the mains
plug into the socket.
Wet grass clippings are sticking
to the underside of the deck.
Missing mulching plug.
Possible clogging.
Height of cut is too low.
The grass is too high.
The grass is wet or damp.
The grass is dense.
The cutting blade is obstructed. and clear obstruction (always
The blade nut/bolt is loose.
The blade nut/bolt is loose.
Cutting blade is damaged.
The battery contacts are
contaminated.
Socket outlet, fuse, mains cable
or battery charger are defective.
The battery has a fault.
Mains plug of the battery
charger is not plugged in
(properly).
Socket outlet, mains cable or
battery charger are defective.
29
Wait until the grass dries before
mowing.
Install the mulching plug.
Check underneath the mower
and clear out as necessary
(always wear gardening
gloves).
Increase the height of cut and
walk slower.
Increase the height of cut and
walk slower.
Wait until the grass is dry and
walk slower.
Increase the height of cut, walk
slower and cut more frequently.
wear gardening gloves).
Tighten the blade nut/bolt (25
Nm).
Tighten the blade nut/bolt (25
Nm).
Replace the blade.
Clean the battery contacts (e.g.
by inserting and removing the
battery several times) or replace
the battery.
Check the mains voltage and
fuse, if necessary, contact
aftersales helpline.
Replace the battery.
Insert mains plug (fully) into the
socket outlet.
Check the mains voltage and
if necessary, contact aftersales
helpline.