Legal compliance and Warning
Cumplimiento legal y advertencia
United States Regulation FCC Warning
Radio/TV interference
This device is not equipped with dialing equipment.
Telephones equipped with electronic dialing keys generate and use radio frequency energy, and if not installed and used
properly and in strict accordance with the manufacturer's instructions, may cause interference to radio and television reception.
NOTE: This device has been tested and found to comply with Part 15 if the FCC rules. Operation is subject to the following
two conditions:
1.
This device may not cause harmful interference and
2.
This device must accept any interference received, including interference that may cause undesirable operation.
If your device causes interference, one of the following measure may correct the problem:
.
Reorient o relocate the receiving TV o radio antenna, when this may be done safely.
.
To the extent possible, move the device and the radio o television farther away from each other, o connect the computer
with the device and the radio o television to outlets on separate circuits.
.
Consult the dealer o an experienced radio/television technician for additional suggestions.
NOTE: FCC registration does not constitute an expressed o implied guarantee of performance.
Right of the Telephone Company
If this device causes harm to the telephone network, the telephone company may stop your service temporarily o ask you to
remove your equipment until the problem is resolved. If possible, they will notify you in advance. If advance notice is not
practical, you will be notified as soon as possible and be given the opportunity to correct the situation. You will also be informed
of your right to file a complaint with the FCC.
Your telephone company may make changes in its facilities, equipment, operations or procedures that could affect the proper
function of this device. If they do, you will be notified in advance to give you an opportunity to maintain uninterrupted telephone
service.
Federal communication commission (FCC) Notice
FCC Registration Number: This device complies with Part 68, Rules and Regulations, of the FCC for direct connection to the
Public Switched Telephone Network (the FCC registration number and REN number appear on a sticker). If requested, this
information must be provided to the telephone company.
Your connection to the telephone line must comply with these FCC rules:
.
Use only an FCC standard RJ11W/RJ14W or RJ11C/RJ14C network interface jack and FCC compliant line cord and plug
to connect to the telephone line. (To connect the device press the small plastic tab on the plug at the end of the
telephone's line cord. Insert into a jack until it clicks. To disconnect, press the tab and pull out.)
.
If a network interface jack is not already installed in your location, you can order one from your telephone company. Order
RJ11W/RJ14W for wall mounted telephones or RJ11C/RJ14C for desk/table use. In some states, customers are permitted
to install their own jacks.
.
This device may not be connected to a party line or coin telephone line. Connection to Party Line Service is subject to
state tariffs (contact the state public utility commission, public service commission or corporation commission for
information).
.
It is no longer necessary to notify the telephone company of your device's Registration and REN number however, you
must provide this information to the telephone company if they request it.
.
If trouble is experienced with this equipment, for repair or warranty information please contact:
MCDI SECURITY PRODUCTS INC.
Local dealer or
7055 Jean-Bourdon Montréal Québec Canada
Operating guide for Alarm Receiver Decrypta 4
+514.481.1067 www.mcdi.com d4@mcdi.com
57|67