Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate, or install the
product.
WARNING
• Follow the installation instructions carefully. Proper installation is the installer's responsibility.
• Failure to follow correct installation procedures can result in the faucet being loose, which can
result in serious injury.
CAUTION
• Check local building codes before you begin installation to ensure compliance.
PREPARATION
Before beginning the assembly of this product, make sure all parts are present. Compare parts with
the package contents list. If any part is missing or damaged, do not attempt to assemble the product.
Contact customer service for replacement parts.
Estimated Assembly Time: 30 minutes (including removal of old faucet).
Tools Required for Assembly (not included): Adjustable Wrench, Phillips Screwdriver, Silicone Sealant,
Allen Wrench.
Helpful Tools (not included): Basin Wrench, Water Supply Lines.
ASSEMBLY INSTRUCTIONS
1. Install the faucet:
Shut off the water supply. Remove the old faucet. Clean
the mounting surface.
remove the screw protection sleeves from the inlet tube.
Remove the preassembled mounting nuts (C) from the
faucet (A) and place the base plate (B) and the faucet
(A) in position on the sink. From under the sink, thread
the mounting nuts (C) onto the faucet (A). Tighten the
mounting nuts (C). Do not overtighten.
Note: Silicone sealant is required under the base plate
(B).
Before installing the new faucet,
1
C
3
A
B
Publicidad
