Publicidad
Idiomas disponibles
Idiomas disponibles
CYLINDER
1. Remove spark plug.
2. Pour one ounce (29 ml) of oil through
spark plug hole
into cylinder.
3.
Pull starter handle slowly a few times to
distribute oil.
4.
Replace with new spark plug.
OTHER
o Do not store gasoline from one season
to another.
o Replace your gasoline can if your can
starts to rust. Rust and/or dirt in your
gasoline will cause problems.
o If possible, store your unit indoors and
cover it to protect it from dust and dirt.
o Cover your unit with a suitable protec-
tive cover that does not retain moisture.
Do not use plastic.
Plastic cannot
breathe, which allows condensation
to
form and will cause your unit to rust.
IMPORTANT:
Never cover mower while
engine and exhaust areas are still warm.
&CAUTION:
Never store the lawn
mower with gasoline in the tank inside a
building where fumes may reach an open
flame or spark. Allow the engine to cool
before storing in any enclosure.
TROUBLESHOOTING
= See appropriate
section
in manual
unless
directed
to a Sears Parts & Repair Center.
PROBLEM
Does not start
Loss of power
CAUSE
1. Dirty air filter.
2. Out of fuel.
3. Stale fuel.
4. Water in fuel.
5. Spark plug wire is
disconnected.
6. Bad spark plug.
7. Loose blade or broken
blade adapter.
8. Control bar in released
position.
9. Control bar defective.
10. Fuel valve lever (if so
equipped)
in OFF position.
11. Weak battery (if equipped).
12. Disconnected
battery
connector (if equipped).
13. Blown fuse (if equipped).
14. Engine control lever is
in STOP position.
1. Rear of lawn mower
housing or cutting blade
dragging in heavy grass.
2. Cutting too much grass.
3.
Dirty air filter.
4. Buildup of grass, leaves,
and trash under mower.
5. Too much oil in engine.
6. Walking speed too fast.
CORRECTION
1. Clean/replace
air filter.
2.
Fill fuel tank.
3. Drain fuel tank and refill tank
with fresh, clean gasoline.
4.
Drain fuel tank and refill tank
with fresh, clean gasoline.
5. Connect wire to plug.
6. Replace spark plug.
7. Tighten blade bolt or
replace blade adapter.
8. Depress control bar to
handle.
9. Replace control bar.
10. Turn fuel valve lever
to the ON position.
11. Charge battery.
12. Connect battery to engine.
13. Replace fuse.
14. Place engine control lever
in FAST position.
1. Raise cutting height.
2.
Raise cutting height.
3. Clean/replace
air filter.
4. Clean underside of mower
housing.
5. Check oil level.
6. Cut at slower walking speed.
18
Publicidad
