Publicidad
Idiomas disponibles
Idiomas disponibles
Transportation and handling
!
c a u t i o n
•
Do not use any sprays such as insecticide, lacquer, hair spray or
other flammable gases within approximately one (1) meter from the
system.
•
If circuit breaker or fuse is often activated, stop the system and
contact your service contractor.
•
Do not perform installation work, refrigerant piping work, drain piping
and electrical wiring connection without referring to our Installation
and Operation Manual. If the instructions are not followed, it may
result in a water leakage, electric shock or a fire.
•
Check that the ground wire is securely connected. If the unit is not
correctly grounded, it lead electric shock. Do not connect the ground
wiring to gas piping, water piping, lightning conductor or ground
wiring for telephone.
•
Connect a fuse of specified capacity.
•
Do not put any foreign material on the unit or inside the unit.
•
Make sure that the outdoor unit is not covered with snow or ice,
before operation.
•
Before performing any brazing work, check to ensure that there is no
flammable material around. When using refrigerant be sure to wear
leather gloves to prevent cold injuries.
•
Protect the wires, electrical parts, etc. from rats or other small
animals. If not protected, rats may gnaw at unprotected parts and
which may lead to a fire.
•
Fix the cables securely. External forces on the terminals could lead
to a fire.
2 tranSportation and Handling
!
c a u t i o n
•
Do not perform installation work without referring to Installation and Operation Manual. If the instructions are not followed, it may result in a water
leakage, electrical shock, fire, or injury from falling of the expansion valve kit.
•
Do not step or put any material on the expansion valve kit.
2.1 Specification
rated power supply voltage
installation location
Weight
?
n o t e
•
While cooling operation, dew condensation water may occur on the cabinet under the following conditions.
- Ambient temperature: DB 27
- Relative humidity: over 80%
•
Especially a new house built in a rainy season contains higher humidity in the false ceiling and dew condensation water may easily occur on the
outer surface of the indoor unit. In this case, utilize the insulation to the outer surface of the expansion valve kit.
2.2 tranSportation
1 Transport the product to the installation location without removing any packing material.
2 Do not put any material on the expansion valve kit when transporting.
2.3 combination of indoor unit
The expansion valve kit can be combined with only one (1) indoor unit (0.4 to 1.5HP)*.
* expansion valve kit for wall type only
2
DC12V
(Supplied from indoor unit)
Indoor installation (Ex: Inside of false ceiling)
(Outdoor installation is not available)
1.5 kg
C (approx.)
o
PMML0268A rev.4 - 02/2020 - P5416576
?
n o t e
•
Do not install the indoor unit, outdoor unit, remote control switch and
cable within approximately 3 meters from strong electromagnetic
wave radiators such as medical equipment.
•
Supply electrical power to the system to energize the oil heater for 12
hours before start-up after a long shutdown.
•
Do not step or put any material on the product.
•
Provide a strong and correct foundation so that;
a The outdoor unit is not on an incline.
b Abnormal sound does not occur.
c The outdoor unit will not fall down due to a strong wind or
earthquake.
•
Do not fasten flare nut hard. It may cause breakage with aged
deterioration and refrigerant leakage. Use a specified flare nut.
Publicidad
