Publicidad
Idiomas disponibles
Idiomas disponibles
Immediately
prepare
your lawn mower for
storage at the end of the season
or if the
unit will not be used for 30 days or more.
LAWN MOWER
When lawn mower is to be stored for a
period of time. clean it thoroughly, remove
all dirt, grease, leaves, etc. Store in a
clean, dry area.
1. Clean entire lawn mower (See
"CLEANING"
in the Maintenance
section of this manual).
2. Lubricate as shown in the Mainte-
nance section of this manual.
3. Be sure that all nuts, bolts, screws,
and pins are securely fastened.
Inspect moving parts for damage,
breakage
and wear. Replace
if
necessary.
4. Touch up all rusted or chipped paint
surfaces; sand lightly before
painting.
HANDLE
You can fold your lawn mower handle for
storage.
1. Squeeze
the bottom
ends of the lower
handle
toward
each other until the
lower
handle
clears the handle
bracket,
then move handle forward.
2.
Loosen
upper handle
mounting
bolts
enough
to allow upper handle to be
folded
back.
IMPORTANT:
When folding
the handle
for storage
or transportation,
be sure to
fold the handle as shown
or you may
damage
the control
cables.
• When setting
up your handle from the
storage
position,
the lower handle
will
automatically
lock into the mowing
position.
SQUEEZE
TO FOLD
control bar
Upper
Lower
FOLD
BACKWARD
,g
position
ENGINE
FUEL SYSTEM
IMPORTANT:
It is important
to prevent
gum deposits from forming
in essential
fuel system parts such as carburetor, fuel
filter, fuel hose, or tank during storage.
Also, alcohol blended fuels (called
gasohol or using ethanol or methanol)
can attract moisture which leads to
separation
and formation
of acids during
storage. Acidic gas can damage the fuel
system of an engine while in storage.
1. Drain the fuel tank.
2.
Start the engine and let it run until the
fuel lines and carburetor
are empty.
• Never use engine
or carburetor
cleaner
products
in the fuel tank or permanent
damage
may occur.
• Use fresh fuel next season.
NOTE:
Fuel stabilizer
is an acceptable
alternative
in minimizing
the formation
of
fuel gum deposits
during storage.
Add
stabilizer
to gasoline
in fuel tank or
storage
container.
Always
follow the mix
ratio found
on stabilizer
container.
Run
engine at least 10 minutes
after adding
stabilizer
to allow the stabilizer
to reach
the carburetor.
Do not drain the gas tank
and carburetor
if using fuel stabilizer.
ENGINEOIL
Drain oil (with engine warm) and replace
with clean engine oil. (See "ENGINE"
in
the Maintenance
section of this manual).
16
Publicidad
