Elicent R10 PIR Manual De Instrucciones página 17

protected area
OPERATION
By switching the main power supply on, the R10-PIR controller
reaches its stand-by position.
The sensor switches on by detecting the moving body heat
of the person passing through its detection area (Fig 1-2) and
automatically activates the connected unit.
When the person's presence is no longer detected, the unit
will switch off after the pre-set overrun period is elapsed
(timer function).
The front green light indicates that the sensor is detecting.
SETTING OF THE TIMER FUNCTION
The controller is provided with an overrun timer function,
adjustable from 3 to 25 minutes.
How to set the timer:
- Dismantle the front cover
- Set the overrun time by turning the trimmer (Fig.13-A)
- Assemble the front cover.
TROUBLE SHOOTING
The appliance connected to the controller does not run?
1.No voltage – check the connection to the main supply or
that to the unit
2.Be sure the protection fuse (Fig.15 - F) is not interrupted.
Should it be interrupted, replace it with one of the same
features.
In any case, please contact a qualifi ed technician.
DISMANTLING AND RECYCLING
The product has been designed and constructed using high-
quality materials and components that can be recycled and
reutilised. Conform to the local norm regarding the disposal of
waste electric and electronic appliances. A correct dismantling
and disposal of products helps to prevent environmental
pollution and possible injury to health.
17