Publicidad
Idiomas disponibles
Idiomas disponibles
Audio Adjustments
Introduction of audio
adjustments
1
Press MULTI-CONTROL to display the
main menu.
2
Use MULTI-CONTROL to select AUDIO.
Turn to change the menu option. Press to se-
lect.
3
Turn MULTI-CONTROL to select the
audio function.
Turn MULTI-CONTROL to switch between the
audio functions in the following order.
FADER/BALANCE (balance adjustment)—
PRESET EQUALIZER (equalizer recall)—
EQ SETTING 1 (equalizer adjustment)—
EQ SETTING 2 (equalizer fine adjustment)—
LOUDNESS (loudness)—SW SETTING 1 (sub-
woofer on/off setting)—SW SETTING 2 (sub-
woofer setting)—HIGH PASS FILTER (high
pass filter)—BASS BOOST (bass boost)—
SRC LV ADJUST (source level adjustment)
4
Press MULTI-CONTROL to display the
setting mode of each function.
5
Adjust the each function.
Notes
! You can also select the audio function by
pressing AUDIO on the remote control.
! To return to the previous display, press BACK.
! To return to the main menu, press and hold
BACK.
! To return to the ordinary display, press
BAND/ESC.
! You can select the SW SETTING 2 only when
subwoofer output is turned on in
SW SETTING 1.
! When selecting FM as the source, you cannot
switch to SRC LV ADJUST.
! If you do not operate functions within about
30 seconds, the display automatically returns
to the ordinary display.
Using balance adjustment
You can change the fader/balance setting so
that it can provide the ideal listening environ-
ment in all occupied seats.
1
Use MULTI-CONTROL to select
FADER/BALANCE in the audio function
menu.
2
Press MULTI-CONTROL to display the
setting mode.
3
Press MULTI-CONTROL to select the seg-
ment you wish to set.
Press MULTI-CONTROL repeatedly to switch
between fader and balance.
4
Turn MULTI-CONTROL to adjust speaker
balance.
Front/rear speaker balance can be adjusted
between FAD F15 and FAD R15.
Left/right speaker balance can be adjusted be-
tween BAL L15 and BAL R15.
# You can also perform the same operations by
pushing MULTI-CONTROL up or down.
# FAD 0 is the proper setting when only two
speakers are used.
# When the rear output setting is SUB W, ad-
justing the front/rear speaker balance is not effec-
tive. Refer to Setting the rear output and
subwoofer controller on page 30.
Using the equalizer
The equalizer lets you adjust the equalization
to match the car's interior acoustic character-
istics as desired.
Recalling equalizer curves
There are six stored equalizer curves which
you can easily recall at any time. Here is a list
of the equalizer curves.
Section
03
25
En
Publicidad
