Publicidad
Idiomas disponibles
Idiomas disponibles
6.3.
BRUSH ASSEMBLY / DISASSEMBLY
• Never use the machine if the brush or the pad
holder with abrasive pad is not perfectly installed.
Assembly:
Place the brush on the floor;
lift the squeegee using the lifting/lowering lever (
Photo 2 - B )
Holding the handlebar ( Photo 1 - A ) push it down-
ward in order to lift the front part of the machine by
rotating it on the rear wheels;
move the machine and place it over the brush, taking
care that the coupling flange on the brush is under
the metal coupling of the machine ( Photo 20 ).
Switch on the machine using the key switch ( Photo
8 - A ) or the general ON/OFF switch on the control
panel ( Photo 5 - A ).
Select the brush rotation with the brush switch (
Photo 5 - D ; Photo 7 - C ) and start the brush rotation
pulling the control lever ( Photo 2 - A ): the brush will
couple automatically.
To assemble the pad holder follow the same procedure.
• Do not allow the length of the rows of brushes to
become lower than 1 cm.
• Do not allow the thickness of the abrasive disks to
become less than 1 cm.
Working with excessively worn brushes or excessively
thin abrasive disks may damage the machine and the
floor.
Regularly check the wear on these parts before start-
ing to work.
Disassembly or replacement:
Lift the squeegee using the lifting/lowering lever (
Photo 2 - B )
Holding the handlebar ( Photo 1 - A ) push it down-
ward in order to lift the front part of the machine by
rotating it on the rear wheels;
Select the brush rotation with the brush switch ( Photo
5 - D ; Photo 7 - C ) and start the brush rotation pull-
ing the control lever ( Photo 2 - A ) while holding the
machine lifted up; release the control lever to stop the
rotation: the brush will unhook automatically.
To disassemble the pad holder follow the same pro-
cedure.
6. OPERATING INFORMATIONS
6.4.
To transport the machine while not working, proceed
as follows:
Switch OFF the machine using the key switch ( Photo
8 - A ) or the general ON/OFF switch on the control
panel ( Photo 5 - A ).
lift the squeegee using the lifting/lowering lever (
Photo 2 - B ).
Holding the handlebar ( Photo 1 - A ) push it down-
ward in order to lift the front part of the machine by
rotating it on the rear wheels;
While holding the machine in this position, push it to
the new working area or to the parking area.
40
MACHINE TRANSPORT
Photo 20
Photo 21
Publicidad
