Publicidad
Idiomas disponibles
Idiomas disponibles
USING YOUR THROW
Getting Started
Ensure the remote connector is securely connected to the heated throw. (As
shown above).
Note: Make sure the remote is connected to the throw before plugging it into
a socket. If you see a 'P' error on the remote, unplug the throw f rom the socket,
connect the throw to the remote as shown above, then plug it back in.
Turning on
1.
Plug the power lead into the closest socket.
2.
Hold the On/Off Button down for two seconds to turn the heated throw on.
The timer and heating number will illuminate.
3.
Press the Temperature up and down buttons to choose your preferred heat
setting.
Preheating
It is recommended for the heated throw to be preheated for at least 30 minutes
before use.
Setting the correct temperature
Press the Temp button, the heat settings will change on the left of the controller
display. Keep pressing the Temp button until you reach the desired heat set-
ting. The temperature settings range f rom '1' being the lowest to '10' being the
highest.
NOTE: If the heated throw runs on heat settings 5-10 for 3 hours it will
automatically change to heat setting 4.
Setting a timer
When the heated throw is turned on it is automatically set on a 1-hour timer.
Press the Time button to set a timer for up to 10 hours. By continually pressing
8 of 64 | English
the Time button you will cycle through the time options in 1 hour increments.
Once you have reached your desired time setting, the controller will start the
timer.
After the desired time has elapsed, the heated throw will switch to standby
mode, show '- -' on the screen and stop generating heat.
To restart the heated throw after the timer has elapsed, press the On/Off button
once to turn the unit off. Then hold down the On/Off button for 2 seconds to turn
the unit on.
CLEANING YOUR HEATED THROW
WARNING: Always turn the appliance OFF, unplug the power cord f rom the
electrical outlet and allow the appliance to completely cool down before
handling or cleaning it.
CAUTION: Do not connect the appliance to the power supply in order to dry
it. Do not dry the appliance in the sun or use an iron to dry it as this will
damage the insulation layer of the appliance.
CAUTION: Do not use any abrasive cleaners or solvents, as this can damage
the appliance.
•
Do not attempt to clean the appliance in any other way than that detailed
by the manufacturer.
Important note: The Cosi Home heated throw can be washed but NEVER dry
cleaned.
Washing:
•
ALWAYS DISCONNECT THE CONTROLLER AND POWER LEAD FROM THE
HEATED THROW BEFORE WASHING.
•
When hand washing, use a mild washing powder or detergent and warm
water. Soak for f ive minutes and gently wash and rinse thoroughly in clean
water.
•
For machine washing, wash on a gentle cycle at a maximum of 40°C.
English | 9 of 64
Publicidad
