mspa Soho P-SH069 Manual De Instrucciones página 10

Note:
Before inflation, check whether the manometer cap is screwed up tight on the valve of pool body. If not, please tighten and then inflate.
After inflation, the manometer cannot be removed, otherwise the air will be released.
When the Yellow section is pushed out, the Spa inflation is completed. You can fill the Spa with water.
After water filling is completed, check the air pressure once again to ensure the manometer reaches its Green section. Always ensure the
manometer is in the Green section during use.
If the White section of the manometer appears, the spa is over inflated. Rotate the valve cap counter clockwise, have the air released till the Green
section is pushed out, then tighten it clockwise.
To avoid over inflation caused by warm weather or sunshine when leaving spa for weeks inflated and filled with water in temperature higher than
20°C (68°F), please release some air to make sure the manometer is always on in the Yellow section.
5. Spa Bladder Inflation.
5.1 Open the air valve (c) on the spa pool. Ensure that you select the black one. Open the air valve (a) on
the bladder. Insert the inflation hose (b) into the valve.
5.2 Press the Bubble
BUBBLE
5.3 Press Bubble button to turn off the function. Disconnect the inflation hose from the air blower
BUBBLE
outlet and the valve.
5.4 Replace the air valve cap (c) back. Close and recess the inflation valve (a).
6. Water Filling
6.1 Check the spa mark is at the selected area and point the drain valve toward a suitable draining
area before inflation.
6.2 Fill the spa tub with fresh water to the level line marked on the inside of the spa tub. Do not over
fill the spa. It is recommended to fill the spa with lukewarm water for quick heating and energy
saving. Using tap water for spa filling to minimize the influence of unwanted content, such as
minerals.
WARNING:
● Fill the spa tub with fresh water to the level line marked on the inside of the spa tub.
● Never pour water with a temperature higher than 40°C (104°F) directly into the spa.
● To avoid control system failure, do not operate the spa until water reaches the water line.
6.3 After water filling, double check the spa pool air pressure to make sure the manometer points out to the Green section.
6.4 Install the filter cartridge. Please refer to the instruction on P13.
6.5 Place the inflated air bladder and the zipper spa cover over the spa tub. Make sure the spa cover is zipped and locked by the digital lock in the
accessory pack.
IMPORTANT:
● Inspect the spa pressure regularly for leak, premature wear, or deterioration.
● Check and wax the zipper regularly, to make it smooth for operation and to avoid splits.
● Always keep the spa cover on to minimize heat loss when heating the water.
● Make sure the cover, and mostly its side facing water, will not come into contact with the ground or any other dirt when not in use.
● Covers shall be cleaned inside and out periodically using a suitable solution that includes adequate disinfection (e.g. 10ml/l of free Chlorine).
6.5
button to inflate until the bladder is firm to touch but not hard.
10
Yellow
Green
White
5
(c)
6
(b)
(a)