mspa Soho P-SH069 Manual De Instrucciones página 9

1. Plug the machine into the mains.
2. The GFCI plug might automatically reseted. If the RESET indicator is not red, press the RESET button.
3. Press the TEST button on the GFCI. The GFCI indicator should shut off. If the GFCI indicator does not turn off, the GFCI is faulty. Do not use the spa.
Contact a qualified electrician to correct the fault.
4. Press the RESET button on the GFCI again. The indicator should turn red. If yes, the spa is ready for use.
1.
Do not use
faulty sockets
or plug
boards.
Spa Control Unit Connected External Equipotential Bonding Conductors
A qualified electrician should wire the spa control unit to the household equipotential terminal using a minimum 1.5mm² solid copper conductor.
SPA SET-UP
1. Move the entire package to the selected site. Open the carton carefully as it can be used to store the spa during long term storage or when not in use.
2. Lay out all the parts on the ground and make sure all parts are accounted for. Make sure the spa tub is right side up. (*For missing or damaged part,
contact the MSpa Service Center)
3. Spread the Heat Preservation Ground Mat over a cleared area. Spread out the spa liner over the ground mat. The heat Preservation Mat prevents heat
loss from the bottom of the unit.
1
●
NOTE:
SOHO P-SH069: Spread out the square ground mat and
place it to the selected site. Make sure the buckle of cover
and mat is attached when the spa is not in use.
4. Spa Inflation
4.1 Plug the spa into the grounded supply socket.
4.2 Press the RESET button on the GFCI, the screen on controller shows numbers.
4.3 Turn the inflation knob to the inflation status <ON> and long press (≥2 minutes) the bubble button on the controller to start inflating until the yellow
section of the manometer is pushed out.
4.4 Stop pressing the bubble button and turn the knob back to <OFF> for activating other functions.
4.3
ON
2.
RESET
TEST
RESET
2
BUBBLE
°C
°F
HEATER FILTER
BUBBLE TIMER
UP DOWN
3.
RESET
TEST
TEST
3
this side
face down
9
4.
RESET
TEST
Indicator area
4.4
Yellow
OFF