Descargar Imprimir esta página

WAGNER W660 Manual Del Usuario página 33

Ocultar thumbs Ver también para W660:

Publicidad

Idiomas disponibles

Idiomas disponibles

W 660
Paints containing solvents and water-soluble paints,
primers, vehicle coating paints, thick-film glazes
2.
If the convey capacity is too low, add 5 - 10 % dilution step-by-step until the convey
capacity fulfils your requirements.
Start-up
Before connecting to the mains supply, be sure that the supply voltage is identical with
the value given on the rating plate.
Attach the carrying strap to the unit.
Unscrew the container from the spray gun.
Aligning suction tube.
If the suction tube is positioned correctly, the container contents can be sprayed
without almost any residue.
When spraying horizontal surfaces, turn suction tube forward. (Fig. 3 A)
When spraying objects overhead, turn suction tube back. (Fig. 3 B)
Set the container on a sheet of paper, pour in the prepared coating material and
screw the container tightly onto the spray gun.
Connect the front part with the rear part of the gun. (Fig. 5)
Mount the air hose (Fig. 4, a + b). Insert the air hose firmly into the connection of the
unit and the gun handle. The position of the hose is not relevant.
Insert the spray gun into the gun holder on the unit.
Put the machine down only on a level, clean surface. Otherwise, the gun may suck in
dust, etc.
Sling on the carrying strap with the unit.
Remove the spray gun from the gun holder and point it at the object to be coated.
It is advisable to test spray cardboard or a similar material in order to determine the
material quantity and the spray pattern.
Press the ON/OFF switch at the device.
Three different spray jet settings can be chosen on the spray gun, depending on the
application and target object.
Selecting the Spray Setting
Fig. 6 A = vertical flat jet
Fig. 6 B = horizontal flat jet
Fig. 6 C = circular jet
Adjusting the desired Spray Setting (Fig. 7)
With the union nut (1) slightly unscrewed, turn the air cap (2) to the desired spray-setting
position (arrow). Then tighten the union nut.
WARNING!
All manuals and user guides at all-guidesbox.com
Thinning recommendation
(Fig. 2)
(Fig. 3)
 for horizontal surfaces
 for vertical surfaces
 for corners, edges and hard-to-reach
Danger of injury!
Never pull the trigger guard while adjusting the air cap.
surfaces
GB
dilute by 5 - 10 %
27

Publicidad

loading