Metabo AS 20 L PC Manual Original página 21

• Nozzle, tubes or hose blocked?- clean.
11.2 Device will not start
• Is the plug in the plug socket?
• No power from mains?
• Mains lead OK?
• Device hood correctly closed?
• Has the water sensor cut off? - Empty the
container; then switch on and off again.
• Switch (12) in "AUTO" position? - Set to "I"
position. See chapter 7.1.
• The vacuum cleaner is not switched on or off by
means of a power tool, even though switch (12) is
set to the "AUTO" position. - Connect the power
tool to the plug socket (5) .
Do not interfere with the device. Contact
an authorized workshop or Metabo's after-
sales service department (see chapter 13. on
Repairs).
f
12. Accessories
Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
Accessories, see page 4.
For a complete range of accessories, see
www.metabo.com or the catalogue
13. Repairs
Repairs to devices must be carried out by qualified
electricians only!
Use only original Metabo spare parts.
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. For
addresses see www.metabo.com.
You can download a list of spare parts from
www.metabo.com.
14. Environmental Protection
Metabo's packaging can be 100% recycled.
Worn-out devices and accessories contain large
amounts of valuable raw materials and plastics,
which can also be recycled.
Packaging materials must be disposed of according
to their labelling in accordance with municipal
guidelines. Further information can be found at
www.metabo.com in the "Service" section.
These instructions are printed on chlorine-free
bleached paper.
For EU countries only: Never dispose of
appliances in your household waste! In
accordance with European Guideline 2002/
96/EC on used electronic and electric equipment
and its implementation in national legal systems,
used devices must be collected separately and
returned for environmentally compatible recycling.
15. Technical Data
Explanatory notes on the specifications on page 2.
Changes due to technological progress reserved.
K = dust class. As per EN 60335-2-69.
A = outer dimensions
U = mains voltage
F = main frequency
I = current consumption
N = mains connection lead
P = rated input power
1
p = max. vacuum (at the hose)
U1
p = max. vacuum (at blower)
U2
V = max. volume flow (at hose)
l/s1
V = max. volume flow (at blower)
l/s2
D = max. flow rate (at hose)
max1
D = max. flow rate (at the blower)
max2
V = max. container volume
m = weight (without mains cable)
S = suction hose diameter
Ø
S = suction hose length
L
Vibration total value (vector sum of three
directions):
Typical A-effective perceived sound levels:
L = sound pressure level
pA
K ,K =uncertainty
PA WA
IP = protection class
During operation the noise level can exceed
80 dB(A).
Wear ear protectors!
Measured values determined in conformity with EN
60704.
~
AC Power
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
ENGLISH en
21