Maytag HAVS-1 Guía De Uso Y Cuidado página 9

Control features vary by modeL
Prewash
Regular
Heavy
Normal
Li_ht Signal
Rinse
Ltic Temperature Control / 25 Cycles
Spin
Rinse ,t
Handwash
ti_h
D ,. , Normal
ellca_es Heavy
Permanent Press
Prewash
Off
Spin
3ff i
Fin_,er
Faucet
Pull to Start - Push to Stop
_/
Select Cycle
To select a cycle, push the control dial IN and turn it to
the right (clockwise) until the pointer is at the soil level
needed for the wash load.
Permanent PresslDelicates Cycles
Permanent Press/Delicates cycles share the same
portion of the control dial. For permanent press fabrics,
select the cycle and turn the Fabric Selection dial to
Perm. Press. For delicate loads select Delicate.
Regular Cycle
This cycle provides up to 16 minutes of agitation.
Select the Regular Fabric Selection.
Soak Only (select models)
Provides 4 minutes of agitation, then soak. Avoid
extended soaking - soak for 30 minutes or less.
The control dial must be manually advanced to a spin
setting to spin and drain the water.
(if desired)
Select Options
Extra Rinse
When the switch is in the "On" position, an additional
rinse at the end of the Regular and Permanent Press
cycles is provided to more completely remove laundry
additives, suds, perfumes, etc.
End of Cycle Signal
The end of cycle signal will sound once the cycle is
completed. The end of cycle signal can be canceled by
setting the switch to off.
Pull Control Dial Out to Start
You may stop the washer at any time by simply
pushing the control dial IN. Therefore it is possible to
obtain a non-agitated soak or to shorten, skip or
repeat any part of a cycle. The control dial must be
pushed IN (off position) when you change the setting.
Note
• Do not attempt to turn the control dial
counterclockwise. Damage to the timer will result.