Publicidad
Idiomas disponibles
Idiomas disponibles
dangerous goods legislation requirements.
Transport batteries only when the battery housing is undamaged. Pack up the batteries in such a manner
that cannot move around in the packaging.
MAINTENANCE
Remove the battery from the machine before carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free of dust.
(1) Do not attempt to repair the machine unless you have the proper tools and instructions for disassembly
and repair of the machine.
(2) Check bolts at frequent intervals for proper tightness to ensure that the equipment is in safe working
condition.
(3) After each snow removal session, run the snow thrower for a few minutes to prevent the auger from
freezing. Shut off the motor, wait for all revolving parts to stop completely, and wipe residual ice and snow
off the unit.
CLEANING
1. Switch off the machine, remove the battery pack and wait until the machine comes to a complete stop.
2. Do not use aggressive detergents or solvents. Clean the machine after use with a damp cloth dipped in
mild detergent.
3. Using an object such as a wooden or plastic implement, wipe out any accumulation of snow or other
foreign objects around the area of auger and steel shave plate. Be careful of the sharp edges.
4. Use the chute clean-out tool to clear the discharge chute. Do NOT use hands to clear a clogged discharge
EN
chute.
5. Keep battery connection free of dirt and debris, and clean with a soft and dry brush or cloth.
6. Do not spray water onto the motor and electrical components.
7. Do not use pressure washer to clean your machine.
STORAGE
WARNING: Remove the battery pack. Wear protective gloves when carrying out any
adjustment, servicing or maintenance. Do not place your hand or fingers between blades and
avoid getting pinched or cut.
1. Allow the motor to cool and clean the snow thrower before storing or transporting. Be sure to secure the
unit while transporting.
2. Remove the battery pack from the snow thrower.
3. Inspect the snow thrower carefully for worn, loose, or damaged parts. Check connections and screws and
tighten if necessary. For repairing or replacing parts, contact your Kress dealer.
4. Store the unit, along with the removed battery packs, in a locked, dry place out of the reach of children to
prevent unauthorized use or damage. Cover loosely with a tarp for added protection.
TROUBLE SHOOTING
The following table gives problems and actions that you can perform if your machine does not operate
correctly.
WARNING: Switch the machine off and remove the battery prior to any troubleshooting.
PROBLEM
The handle is not in position.
14
POSSIBLE CAUSE
Handle knobs are not secured.
SOLUTION
Make sure that the knobs are fully
tightened and closed.
Publicidad
