Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
Products are delivered half mounted and can be mounted without tools.
Step 1
Attach the side supports to the frame by depressing push buttons and sliding side supports into the tubes located on each side of
the seat.
Make sure that push button "snap" correctly through holes and that the side supports are stable and adjusted the same way.
Step 2
Attach backrest to the frame, by depressing push buttons and sliding the backrest pipes into the tubes located on each side and
on the back of the seat.
Step 3
Place the bath seat over the bath. At least 25mm of each non-slip arm must rest on the flat sides of the bath. Check stability, the
seat shall not be unstable or shaky.
Version Mai 2023
8
Publicidad
