GE DVM1665 Manual De Instrucciones página 21

ADAPTING BLOWER FOR
C3.
RECIRCULATION
Place the blower unit back into the opening.
5
CAUTION: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
6 Replace blower plate and replace screws for blower
plate and blower motor removed in Step 1.
Blower Plate Screws
C4.
MOUNT THE OVEN
FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE
RECOMMEND THAT TWO PEOPLE INSTALL THIS OVEN.
IMPORTANT: Do not grip or use handle during
installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used,
case damage may occur from over
tightening screws.
Installation Instructions
(continued)
Blower Plate
Back of Oven
Blower Motor Screw
N N O O T T E E : : When mounting
the oven, thread power
cord through hole in
bottom of top cabinet.
Keep it tight throughout
Steps 1–3. Do not pinch
cord or lift oven by pulling
cord.
2 Rotate front of oven
up against cabinet
bottom.
Cabinet Front
Cabinet Bottom Shelf
Oven Top
21
1
Lift oven, tilt it
forward and hook
slots at back bottom
edge onto two lower
tabs of mounting plate.
Filler Block
Equivalent to Depth
of Cabinet Recess
Self-Aligning Screw