Install The Rails - GE JX9152 Instrucciones De Instalación

Ocultar thumbs Ver también para JX9152:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1 LOCATE AND INSTALL THE BASE
PAN
Set Base Pan into the front cabinet microwave
oven cutout and center it right and left. Push back
until the front flange is against the cabinet front wall.
Mount the Base Pan using 3 short screws.
Short
Screw
Base Pan
Mounting Holes

2 INSTALL THE RAILS

Disconnect the microwave oven from the receptacle.
Remove everything out of the microwave oven, including
packing, Owner's Manuals, turntable and turntable
support. A protective film has been applied to some
microwave oven and trim kits. If applied, remove the film.
Turn over the microwave oven and secure the rails to
oven Base Plate by inserting 4 short screws. Be careful
not to scratch the microwave oven.
Microwave
Oven Bottom
Rail
Short
Screw
Flanges
Installation Instructions
Door
3 INSTALL THE REAR DUCT
1. Gently return microwave oven to its upright position.
2. Remove screw A.
Screw A
3. Align the rear duct with the back of microwave oven,
as shown.
4. Slide 2 tabs into the slots on the right side of the back
of microwave oven.
A
5. Use 2 short screws to secure top of rear duct to the
back of microwave oven, as shown.
A
A. Short screws (2)
B. Rear duct
C. Back of microwave oven
3
B
A. Rear duct tabs
B. Slots
B
C

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Jx9153

Tabla de contenido