Craftsman 675 Serie Manual Del Operador página 4

Preparation Operation
1. Always wear safety shoes or heavy boots.
2. Always wear safety glasses or safety goggles when operating
this machine.
3. Never wear jewelry or loose clothing that might become
entangled in moving or rotating parts of the machine.
4. Make sure machine is on a level surface before operating.
5. Always block wheels to prevent unintended movement,
and lock beam assembly in either the horizontal or vertical
position.
6. Always operate this machine from the operator zone(s)
specified in the manual.
7. Logs should be cut with square ends prior to splitting.
8. Use log splitter in daylight or under good artificial light.
SafeHandlingof Gasoline
To avoid personal injury or property damage use extreme care in
handling gasoline. Gasoline is extremely flammable and the vapors
are explosive. Serious personal injury can occur when gasoline is
spilled on yourself or your clothes which can ignite. Wash your skin
and change clothes immediately.
a. Use only an approved gasoline container.
b. Extinguish all cigarettes, cigars, pipes, and other sources
of ignition.
c. Never fuel machine indoors.
d. Never remove gas cap or add fuel while the engine is
hot or running.
e. Allow engine to cool at least two minutes before
refueling.
fl Never overfill the fuel tank. Fill tank to no more than 1/2
inch below bottom of filler neck to provide space for
fuel expansion.
g. Replace gasoline cap and tighten securely.
h. If gasoline is spilled, wipe it off the engine and
equipment and move machine to another area. Wait five
(5) minutes before starting the engine.
i. Never store the machine or fuel container inside where
there is an open flame, spark or pilot light as on a water
heater, space heater, furnace, clothes dryer or other gas
appliances.
j. Allow machine to cool at least five (5) minutes before
storing.
1. Before starting this machine, review the "Safety Instructions".
Failure to follow these rules may result in serious injury to the
operator or bystanders.
2. Never leave this machine unattended with the engine running.
3. Do not operate machine while under the influence of alcohol,
drugs, or medication.
4. Never allow anyone to operate this machine without proper
instruction.
5_
6_
Always operate this machine with all safety equipment in place
and working. Make sure all controls are properly adjusted for
safe operation.
Operator Zone
a. Horizontal Operating Position: Stand behind the
reservoir tank to operate the control handle and to
stabilize the log as shown in Fig. 1.
b. Vertical Operating Position: Stand in front of the beam
and log as shown in Fig. 1.
Horizontal
Vertical
Figure 1
7. Do not change the engine governor settings or overspeed the
engine. The governor controls the maximum safe operating
speed of the engine.
8. When loading a log, always place your hands on the sides
of the log, not on the ends, and never use your foot to help
stabilize a log. Failure to do so, may result in crushed or
amputated fingers, toes, hand, or foot.
9. Use only your hand to operate the controls.
10. Never attempt to split more than one log at a time unless
the ram has fully extended and a second log is needed to
complete the separation of the first log.
11. For logs which are not cut square, the least square end and the
longest portion of the log should be placed toward the beam
and wedge, and the square end placed toward the end plate to
ensure the log remains level and in place on the end plate.
4