MTD 510 Serie Manual Del Operador página 10

Controls a nd Features
4
Cylinder_
,g Dislodger
Control Handle
Horizontal
Beam Lock
Assembly
Vertical
Beam Log
Lock Cradle
Light
NOTE:This Operator's Manual covers several models. Log splitter
features may vary by model. Not all features in this manual are
applicable to all log splitter models and the log splitter depicted
may differ from yours.
EngineControls
See the Engine Operator's Manual for the location and function
of the controls on the engine.
BeamLocks
Figure 4=1
TailLight (if equipped)
The tail light's are located on the back of the frame for
transportation and towing purposes.
WARNING! Do not tow faster than 45mph and
check the local, state, and federal requirements
before towing on any public road.
Log Dislodger
These two locks are used to secure the beam in the horizontal or
vertical position. The vertical beam lock is located next to the oil
filter. The horizontal beam lock is located on the beam support
latch bracket.
The log dislodger is designed to remove any partially split wood
from the wedge. This may occur while splitting large diameter
wood or freshly cut wood.
Control Handle
Control Handle
The control handle has three positions; Forward, Neutral and
Reverse. See the Operation Section for instructions.
Wedge
The wedge is used to split the wood.
The Control Handle is used to move the wedge up and down to
split wood.
Tongue
The tongue is used to attach to a towing vehicle for
transportation.