Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLE SHOOTING
WARNING:
!
Stop using tool immediately if any of the following problems occur. Serious personal injury
could result. Any repairs or replacements must be done by a qualified service person or an
authorized service center.
PROBLEMS
POSSIBLE CAUSE(S)
O-rings in trigger valve housing are
Air leaking at trigger
damaged
valve area.
Air leaking between
Loose screws in housing
housing And nose.
1.Damaged O-rings
2.Damaged to bumper
Air leaking between
1.Loose screws
housing and Cap.
2.Damaged gasket
Tool skips driving
1.Worn bumper
fastener
2.Dirt in nose piece
3.Dirt or damage prevent fasteners or
pusher from moving freely in
magazine
4.Damaged pusher spring
5.Inadequate air flow to tool
6.Worn O-ring on piston or lack
of lubrication
7.Damaged O-ring on trigger valve
8.Air leaks
9.Cap seal leaking
Tool runs slow or has
1.Tool not lubricated sufficiently
loss of power
2.Broken spring in cylinder cap
3.Exhaust port in cap is blocked
Fasteners are jammed
1.Guide on driver is worn
in tool
2.Fasteners are not correct size
3.Fasteners are bent
4.Magazine or nose screws are loose
5.Driver is damaged
12
CORRECTIVE ACTION
Replace o-rings. Check operation
of Work Contact Element(WCE)
Tighten screws
1.Replace o-rings
2.Replace bumper
1.Tighten screws
2.Replace gasket
1.Replace bumper
2.Clean drive channel
3.Clean magazine
4.Replace spring
5.Check fitting, hose, or compressor
6.Replace and lubricate o-rings
7.Replace o-rings
8.Tighten screws and fittings
9.Replace gasket
1.Lubricate nailer
2.Replace spring
3.Replace damaged internal parts
1.Replace guide
2.Use only recommended fasteners
3.Replace with undamaged fasteners
4.Tighten screws
5.Replace driver
WARRANTY
2 YEARS LIMITED WARRANTY
If within two years from the date of purchase, this Husky air tool product
fails due to a defect in materials or workmanship, please immediately
contact Product Support at
1-866-676-8468
except normal Holiday).Do not return the air tool to the store. Please be
prepared to send the product, postage prepaid, along with a copy of the
dated first owner purchase receipt with the tool
GLOBAL PRODUCTS, INC. Address:201 Ropemill Parkway, suite#1,
Woodstock, GA.
30188. A
defective
replaced
with
a
new
one
of
equal
warranty excludes incidental/consequential damages and failures
due to misuse, abuse or normal wear and tear. This warranty
gives you specific rights, and you may also have other rights, which
vary, from state to state. Please call
1-866-676-8468
(8am to 5pm EST, M-F,
model to: PRIME
product
will
be
promptly
or
greater
value. This
for details.
13
Publicidad
