Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
(continued)
Emptying
the Drum
1. Remove the lid. Pull the flexible latches
outward on each side of the lid to
release from the drum.
2. While holding the latches out, lift the
top assembly up and away from the
drum.
3. Lay top assembly upside down on a
clean area while emptying drum or
changing filter.
4. Dump the drum contents into the
proper waste disposal container.
A
WARNING: To reduce the risk of
back injury or falls, do not lift a vac
heavy with liquid or debris. Scoop or
drain enough contents out to make the
Vac light enough to lift comfortably.
Blowing
Feature
Your Vac features a blowing port. It can
blow sawdust and other debris. Follow
the steps below to use your Vac as a
blower.
A
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
A
WARNING: To reduce the risk of
injury to bystanders,
keep them clear
of blowing debris.
A
CAUTION:
Wear a dust mask if
blowing creates dust which might be
inhaled.
A
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the Vac/Blower for
extended time or in a noisy area.
1. Locate blowing port of your Vac.
2. Insert the locking end of the "Pos-I-
Lock ®''hose into the blowing port of the
Vac. The hose should snap into place.
To remove the hose from the Vac,
press the release button in the hose
assembly and pull the hose out of the
Vac inlet.
3. (Optional) Attach extension wand to
opposite end of hose.
4. Turn Vac on and you are ready to use
your Vac as a blower.
Craftsman recommended
accessories are
available at Sears retail stores and
sears.com. The Sears Car Nozzle Stock
No. 17839 is recommended
for blowing
debris.
Hose
\_
Blowing
Publicidad
