Denon AVR-1611 Manual Del Usuario página 39

Playback
1
ZONE SELECT
Switch to "ZONE2".
The remote control unit switches to the
operating mode for ZONE2.
2
Press AMP .
3
Press ZONE/DEVICE ON to turn
on the ZONE2 power.
The indicator on the display lights.
• Also, pressing any of input source select
button in standby mode turns on the power.
ZONE/DEVICE OFF
• When is pressed, ZONE2
turns off.
• Power in ZONE2 can be turned on or off by
ZONE2 ON/OFF
pressing on the main unit.
4
Press the input source select button.
The audio signal of the selected source is output to ZONE2.
SOURCE SELECT
• Turn after
ZONE2 SELECT
pressing on
the main unit to select an input
source.
When power for both MAIN ZONE and ZONE2 is set to ON, power of
the MAIN ZONE only can be turned off. Select "MAIN" in step 1 then
ZONE/DEVICE OFF
press .
Adjusting the volume
VOL df
Use to adjust the volume.
GAdjustable rangeH – – –
(When the "Volume Display" (vpage 53) setting is "Relative")
GAdjustable rangeH
(When the "Volume Display" (vpage 53) setting is "Absolute")
• At the time of purchase, "Volume Limit" (vpage 53) is set to
"–10dB (71)".
Input source
MASTER VOLUME
Turn
select buttons
unit to adjust the sound volume.
Turning off the sound temporarily
MUTE
Press .
The sound is reduced to the level set at "Mute Level" (vpage 53) in
the menu.
• To cancel, either adjust the volume or press
• The setting is canceled when the zone's power is turned off.
–80dB – –40dB – 18dB
0 – 41 – 99
ZONE2 SELECT
after pressing on the main
MUTE
again.
Quick select function
It is also possible to save three settings for ZONE2.
n Saving the settings
1
Set the items below to the settings
you want to save.
q Input source (vpage 35)
w Volume (vpage 35)
2
Switch ZONE SELECT to
"ZONE2".
The remote control unit switches to the
operating mode for ZONE2.
3
Press and hold the desired QUICK SELECT button until
"Memory" appears on the display.
The current settings will be memorized.
GQuick select defaultsH
Input Source
QUICK SELECT 1 BD
QUICK SELECT 2 SAT/CBL
QUICK SELECT 3 DOCK
n Recalling the settings
1
ZONE SELECT
Switch to
"ZONE2".
The remote control unit switches to the
operating mode for ZONE2.
2
Press QUICK SELECT at which the
settings you want to call out are
saved.
Naming quick select settings
See "Quick Select Name" (vpage 54).
ENGLISH
Volume
–40dB
–40dB
–40dB
35