For technical assistance or to request replacement parts, always give the model, the version and serial number written on the serial number
plate.
This appliance has been built for the professional cleaning of indoor hard vinyl floors, to be carried out by following the instructions. The
appliance must only be used for this purpose.
This appliance was designed and built to be used by a qualified
operator to clean smooth, compact flooring in the commercial,
residential and industrial sectors, in proven safety conditions.
Operator cooperation is paramount for accident prevention. No
accident prevention programme can be effective without the full
co-operation of the operator who is directly responsible for machine
operation. The majority of occupational accidents that happen both
in the workplace or whilst moving are caused by failure to respect
The serial number plate is located on the lower part of the machine
chassis, and indicates the general characteristics of the appliance,
in particular the appliance's serial number. The serial number is a
very important piece of information and should always be provided
together with any request for assistance or when purchasing spare
parts.
TECHNICAL DATA
Working width
Brush rotations
Brush motor power
Brush motor voltage
Brush motor frequency
Maximum gradient with full load
Rear wheel diameter
Machine length
Machine height at motor
Machine height at shaft
Machine width
Machine service weight (without solution tank)
Length of power supply cable
IDENTIFICATION DATA
TECHNICAL DESCRIPTION
INTENDED USE
The appliance is only suitable for use in indoor - or at least covered
- areas.
ATTENTION: The appliance is not suitable for use in the rain,
or under jets of water.
SAFETY
the most basic safety rules. An attentive, careful operator is most
effective guarantee against accidents and is fundamental in order to
implement any prevention programme.
SERIAL NUMBER PLATE
U/M
L010001
mm
rpm
W
V
Hz
%
mm
mm
mm
mm
mm
kg
m
20
S-V
510
1500
1100
230
50
2
100
610
300
1260
545
42
15