Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTING THE iDLE SPEED
_
ARNING"
The saw chain may spin during idle speed
[
adjustments.
Wear protective clothing and observe all
J
safety instructions to prevent serious personal injury.
NOTE: Careless adjustments can seriously damage the unit. A Sears or
other qualified service dealer should make carburetor adjustments.
if, after checking the fuel and cleaning the air filter, the engine still
will not idle, adjust the idle speed screw as follows:
1. Start the engine. Refer to Starting and Stopping.
2. Release the throttle control and let the engine idle.
• if the engine stops, use a small Phillips or flat-head screwdriver
to turn the idle speed screw clockwise, 1/8 of a turn at a time
(as needed) until the engine idles smoothly (Fig. 44).
if the engine idles too quickly, turn the idle speed screw
counterclockwise,
1/8 of a turn at a time (as needed) to reduce
the idle speed (Fig. 44).
NOTE: The saw chain should not spin when the engine idles, if it
does, reduce the idle speed until the saw chain stops moving.
Checking the fuel, cleaning the air filter, and adjusting the idle speed
should solve most engine problems, if not, and any of the following
conditions are true, take the unit to a Sears or other qualified service
dealer:
the engine will not idle
the engine hesitates or stalls on acceleration
there is a loss of engine power
Fig. 44
[die Speed
Screw
MAiNTAiNiNG
THE SPARK
PLUG
1. Stop the engine and allow it to cool.
2. Turn the knob on the air filter cover counterclockwise
to loosen
the air filter cover (Fig. 42).
3. Remove the air filter cover (Fig. 42).
4. Grasp the spark plug boot firmly and pull it from the spark plug
(Fig. 45).
5. Clean around the spark plug. Remove the spark plug from the
cylinder head with the multi-purpose
tool or a 5/8-inch socket
wrench, turning counterclockwise.
_
ARNING:
Do not sand blast, scrape or clean spark plug [
electrodes. Grit in the engine could damage the cylinder.
]
6. inspect the spark plug. if the spark plug is cracked, fouled or
dirty, replace it with replacement part #753=08107, a Champion
ROJ6Y or an equivalent spark plug.
7. Use a feeler gauge to set the air gap at 0.025 in. (0.635 ram)
(Fig. 46).
8. install the spark plug in the cylinder head. Tighten the spark plug
with the multi-purpose
tool or a 5/8-inch socket wrench, turning
it clockwise until snug.
NOTE: if using a torque wrench, torque to:
110-120 in._lb. (12.3=13.5 Nora). Do not over tighten.
9. Reattach the spark plug boot.
10. Place the air filter cover back onto the unit. insert the tab on the
air filter cover into the slot on the chain saw housing (Fig. 42).
11. Turn the knob clockwise to tighten the air filter cover securely.
j
Fig. 45
S
0.025 in.
{0.635 rnrn)
Fig. 46
26
Publicidad
