UFESA FH Crux Dual Blue Manual De Instrucciones página 17

IMPORTANT WARNING
This device is intended solely for domestic use. Before connecting the product to the mains,
check that your mains voltage is the same as or is within the limits indicated on the product
label. Keep this appliance out of the reach of children and people with disabilities. Do not move
the device while in use. Do not leave the power on if you will not be in the same room where
the appliance is. Keep the appliance clean. Do not allow any object into the ventilation system
as it could cause an electric shock, fire or damage the unit. Do not use the appliance to dry
clothes. Always use the device in an upright position. Unplug the unit whenever not in use. Do
not pull the cord to unplug the appliance. Do not use the device if it is cracked or broken. Do not
use the appliance in rooms with a surface less than 4m2. The appliance has a security system
to be disconnected in case of accidental overheating. To keep the unit working again unplug
the power for a few minutes, check that has no object obstructing the air inlet, let the device
cool down and plug it back. Improper use of the product may involve danger and revoke the
warranty and liability. Do not use, connect or disconnect the device to the network with wet
hands and/or feet. Do not wrap the cord around the control button.
B&B TRENDS SL accepts no liability for any damage that may be caused to people, animals or
objects owing to failure to observe this warning correctly.
INSTRUCTIONS FOR USE
The safety instructions marked at the beginning of this manual must be followed at all times
when using this product. Follow the instructions below in order to switch on the appliance:
1. Remove the product from its original packaging taking special care not to damage any of its
parts. Do not use excessive force to remove the product from the box.
2. Switch on the appliance by selecting from the three speed settings (C).
3. Adjust the temperature using the thermostat control (D) clockwise until it clicks, the power
light will illuminate and the fan heater will begin working.
4. Turn the thermostat knob clockwise to increase the temperature or anti - clockwise to de-
crease the temperature.
5. When the desired room temperature has reached, slowly turn the thermostat knob an-
ti-clockwise to the minimal direction until the appliance switches off.
6. This set temperature will be automatically maintained.
7. When you have finished using your heater, turn the thermostat knob anticlockwise all the
way to the lowest position [ - ], turn the power setting switch off and unplug the unit.
Repair:
Only specialized personnel should perform repairs to this electrical appliance. Any incorrectly
performed repair can lead to considerable hazards for the user. In the event of repair, please
always contact our aftersales service. Failure to observe these instructions will lead to the
total loss of the product warranty.
Power selector
0 - OFF
– Fan (for cool air)
[ I ] – Low heating
[ II ] – High heating
17