Rottner EM2020 Manual De Instrucciones página 6

Locking:
Close door and turn handle fully to closing position. The lock is secured. Control blocking status by
trying to turn handle back.
Manipulation protection:
Entry of four consecutive invalid codes – keypad is blocked for 5 minutes. During this period, the
light flashes every 10 seconds and any key press causes a long signal. After expiration, entry of two
more invalid codes, restarts the 5 minute blocking period.
Safety reference:
All codes are to be securely stored. Do not use personal data (i.e. Birthdays, telephone numbers etc.)
as the code. Change the factory code before you start using the safe!
2. ACTIVATE THE SECOND OPENING CODE: (SEE FIG. B)
Press and hold Key [1] until double signal. The light remains on during the following actions.
• Enter main code.
• Enter Secondary code twice (Double signal after each).
(The secondary code can be changed like the main code. With the main code, the secondary code
can be deleted. The main code cannot be deleted).
3. TIME DELAY (MAX. 99 MIN) AND OPEN WINDOW (MAX. 19 MIN)
Hold down the "9" key until a double signal occurs.
The signal light stays on during the following actions.
• Master code is entered.
• Press 2 6 for time delay
Or 1 2 for opening window.
• Press 2 6 1 2 again (double signal each time).
Attention: time delay can only be modified
while the opening window is active.
4. DELETION OF TIME DELAY AND OPENING WINDOW
Hold down the "9" key until a double signal occurs.
The signal light stays on during the following actions.
• Master code is entered.
• Look for the time delay
0 0
And for the opening window
0 1 on.
• 0 0 0 1 reenter (Double tone each).
Attention: The time delay can only be changed when the opening window is active.
...sustained beep after the code was entered and the lock doesn't open?
A wrong code has been entered. Enter a valid code.
...the LED blinks every 10 seconds and a long beep can be heard if any key is pressed?
A wrong code was entered 4 times and the lock is blocked. Wait 5 minutes and enter a valid code.
...no beep after any key is pressed?
Replace the batteries. If the problem is not solved, please contact your dealer.
6 EM2020
5. WHAT IF...