Hach 8398 Serie Instrucciones Para El Usuario página 4

Specification
Temperature
response
Maximum
temperature
Maximum pressure
Sample connection
1.2 Inductive conductivity sensors
Specification
Application
Material
Cell constant K
Accuracy
Measurement range
Conductivity response
Temperature response
Maximum pressure
Maximum temperature
Section 2 General information
In no event will the manufacturer be liable for damages resulting from any improper use of product or
failure to comply with the instructions in the manual. The manufacturer reserves the right to make
changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer's website.
2.1 Safety information
The manufacturer is not responsible for any damages due to misapplication or misuse of this product
including, without limitation, direct, incidental and consequential damages, and disclaims such
damages to the full extent permitted under applicable law. The user is soley responsible to identify
critical application risks and install appropriate mechanisms to protect processes during a possible
equipment malfunction.
Please read this entire manual before unpacking, setting up or operating this equipment. Pay
attention to all danger and caution statements. Failure to do so could result in serious injury to the
operator or damage to the equipment.
Make sure that the protection provided by this equipment is not impaired. Do not use or install this
equipment in any manner other than that specified in this manual.
2.1.1 Use of hazard information
Indicates a potentially or imminently hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a potentially or imminently hazardous situation which, if not avoided, could result in death or serious
injury.
4 English
8315
< 30 seconds
150 °C (302 °F) 150 °C (302 °F)
25 bars (363 psi) 25 bars (363 psi)
¾ inch NPT
Corrosive and fouling applications
0—2000 mS/cm
18 bars (261 psi)
140 °C (284 °F)
W A R N I N G
8316
< 30 seconds < 30 seconds
150 °C (302 °F)
25 bars (363 psi)
¾ inch NPT ¾ inch NPT
8398 series
PEEK
-1
2.35 (cm )
± 2 %
< 1 second
< 2 minutes
D A N G E R
8317 8394
< 30 seconds
150 °C (302 °F)
25 bars (363 psi)
Tri-Clamp 1½ or
2 inch
8332
Measurement in harsh conditions
PVDF
-1
10 (cm )
± 2 %
100 μS/cm—10 S/cm
< 1 second
< 2 minutes
7.5 bars (109 psi)
120 °C (248 °F)