Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING
BA'I-rE RY
_WARNING:
Do not short
battery
terminals
by allowing
a wrench
or any
other
object
to contact
both terminals
at
the same time.
Before
connecting
battery,
remove
metal bracelets,
wristwatch
bands,
rings, etc.
Positive
terminal
must
be connected
first to prevent
sparking
from accidental
grounding.
1.
Lift seat pan to raised
position.
2.
Disconnect
BLACK
battery
cable first
then
RED battery
cable
and carefully
remove
battery
from tractor.
3.
Install
new battery
with terminals
in
same
position
as old battery.
4.
First connect
RED battery
cable to
positive
(+) terminal
with hex bolt and
keps nut as shown.
Tighten
securely.
Slide terminal
cover
over terminal
5.
Connect
BLACK
grounding
cable
to
negative
(-) terminal
with remaining
hex bolt and keps nut. Tighten
securely.
TO REPLACE
FUSE
Replace
with 20 amp automotive-type
plug-in
fuse.
The fuse holder
is located
behind
the dash.
TO REMOVE
HOOD
AND
GRILL
AS-
SEMBLY
1.
Raise hood.
2.
Unsnap
headlight
wire connector.
3.
Stand
in front of tractor.
Grasp
hood at
sides,
tilt toward
engine
and lift off of
tractor.
4. When
replacing
hood,
be sure to re-
connect
the headlight
wire connector.
_
:::_htWire
_/-_
Connector
Terminal
Keps
Rex
Bott
ENGINE
Maintenance,
repair, or replacement
of the
emission
control devices
and systems,
which
are being done at the customers
expense,
may be performed
by any non-road
engine
repair establishment
or individual.
Warranty
repairs must be performed
by an authorized
engine
manufacturer's
service
outlet.
Positive (Red) Cable
Negative
(Black) Cable
TO REPLACE
HEADLIGHT
BULB
1.
Raise
hood.
2.
Pull bulb holder
out of the hole in the
backside
of the grill.
3.
Replace
bulb in holder
and push bulb
holder
securely
back into the hole in
the backside
of the grill.
4.
Close
hood.
INTERLOCKS
AND
RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or
prevent it from starting.
• Check wiring.
See electrical wiring
diagram in the Repair Parts section.
TO ADJUST
THROTTLE
CONTROL
CAB LE
The throttle
control
has been preset
at the
factory
and adjustment
should
not be nec-
essary.
Check
adjustment
as described
below
before
loosening
cable.
If adjust-
ment is necessary,
proceed
as follows:
1.
With engine
not running,
move throttle
control
lever from slow to choke
posi-
tion.
Slowly
move lever from choke
to
fast position.
2.
Check
that holes
'_'
in governor
control
lever and hole in governor
plate
line-up.
If holes '7_' are not aligned,
loosen
clamp
screw
and move throttle
cable
until
holes
are aligned.
Tighten
clamp
screw
securely.
27
Publicidad
