Descargar Imprimir esta página

Craftsman 917.276780 Manual Del Operador página 17

Publicidad

Idiomas disponibles

Idiomas disponibles

_IbCAUTION:
At any time, during
step
4, there may be movement
of the drive
wheels.
4.
Move motion
control
lever to full
forward
position
and hold for five (5)
seconds.
Move lever to full reverse
position
and hold for five (5) seconds.
Repeat
this procedure
three (3) times.
5.
Move motion
control
lever to neutral
(N) position.
Shutoff
engine
and set
parking
brake.
6.
Engage
transmission
by placing
free-
wheel
control
in engaged
position
(See
"TO TRANSPORT"
in this section
of
manual).
7.
Sitting
in the tractor
seat, start engine.
After the engine
is running,
move
throttle
control
to half (1/2) speed.
With motion
control
lever in neutral
(N)
position,
slowly
disengage
clutch/brake
pedal.
8.
Slowly
move motion
control
lever
forward,
after the tractor
moves
ap-
proximately
five (5) feet, slowly
move
motion
control
lever to reverse
position.
After the tractor
moves
approximately
five (5) feet return
the motion
control
lever to the neutral
(N) position.
Repeat
this procedure
with the motion control
lever three (3) times.
Your transmission
is now purged
and now
ready for normal
operation.
MOWING
TIPS
• Mower
should
be properly
leveled for
best mowing
performance.
See "TO
LEVEL
MOWER
HOUSING"
in the
Service
and Adjustments
section
of this
manual.
• The left hand side of mower
should
be
used for trimming.
• Drive so that clippings
are discharged
onto the area that has already
been
cut.
Have the cut area to the right of
the tractor.
This will result in a more
even distribution
of clippings
and more
uniform
cutting.
• When
mowing
large areas,
start by
turning
to the right so that clippings
will
discharge
away from shrubs,
fences,
driveways,
etc.
After one or two rounds,
mow in the opposite
direction
making
left hand turns until finished.
f
1
J
00272
• If grass is extremely
tall, it should
be
mowed
twice to reduce
load and pos-
sible fire hazard
from dried clippings.
Make first cut relatively
high; the second
to the desired
height.
• Do not mow grass when
it is wet.
Wet grass will plug mower
and leave
undesirable
clumps.
Allow grass to dry
before
mowing.
• Always
operate
engine
at full throttle
when
mowing
to assure
better mowing
performance
and proper
discharge
of
material.
Regulate
ground
speed
by
selecting
a low enough
gear to give the
mower cutting
performance
as well as
the quality
of cut desired.
• When
operating
attachments,
select
a
ground
speed
that will suit the terrain
and give best performance
of the at-
tachment
being used.
17

Publicidad

loading