Before
cleaning
the washer
interior,
unplug
the electrical
power
cord
to avoid
electrical
shock
hazards.
When
disposing
of the appliance,
cut off the power
cable,
destroy
the plug,
and disable
the door
lock to prevent
young
children
from
being
trapped
inside.
• The water inlet filter
•" _E " error message will blink on the control panel when water does not enter the dispenser.
• If your water is very hard or contains traces of lime deposit, the water inlet filter may become clogged.
We recommend cleaning it every few months.
1. Turn off the
water tap.
3. Clean the
filter using
a hard
bristle
brush.
• The drain pump filter
• The drain filter collects threads and small objects left in the laundry.
Check regularly that the filter is clean to ensure smooth running of your machine.
2. Unscrew
the water
inlet hose.
4. Tighten
the inlet
hose.
Drain, using the drain hose, before opening the pump filter to remove objects.
Be careful when draining
if the water is hot.
• Allow the water to cool down before cleaning the drain pump filter.
1. Open the lower cover cap (1_
with a tool such as coin.
Turn the drain plug @ to pull
out the hose.
2. Unplug the drain plug _,
allowing the water to flow out.
At this time use a vessel to
prevent water from flowing
onto the floor. When water does
not flow any more, turn the
pump filter _ open to the left.
3. Remove any foreign objects from
the pump filter 3_. After cleaning,
turn the pump filter _ clockwise
and insert the drain plug _2_ to the
original place. Close the lower
cover cap_.
16