KlipXtreme STYLE Manual Del Usuario página 6

• While the headphones are being charged, the LED glows red. The LED will turn
OFF once the battery has reached full capacity.
• When battery is low, the LED indicator will start blinking every five seconds.
Also, when the remaining battery is at 20%, an audible prompt will be heard to
indicate that the headphones need to be recharged.
• Make sure that the headphones are fully charged before using them for the first
time.
*Do not use a USB fast charging or PD adapters with an output power greater
than 5VDC; otherwise, you will damage your headphones and void the warranty.
b. Auxiliary wired connection
• With the headset On or Off, insert the 3.5mm cable to play in Auxiliary mode.
Plug one end of the supplied 3.5mm cable to your headphones and the other
end to the 3.5mm auxiliary port in your input source.
• The LED indicator on the headset will turn off and the headset will
automatically switch to auxiliary in mode.
Note: When the Bluetooth mode is enabled and the auxiliary cable is
®
connected, you will experience a momentary loss of audio as the input changes
to the wired 3.5mm connection.
• Set the desired volume on the input source. The volume controls on the
headphone will not operate when they are connected to an external wired audio
source.
Note: Once you remove the cable, the device will not return automatically to
Bluetooth ® mode. Instead, you must turn the unit off and then on again to
reactivate the wireless function.
V. Advanced operation
Pairing the headset with your mobile device
1. Turn on the headset by pressing and holding the power button. The LED light
will start blinking green and blue indicating that it has entered into the
Bluetooth ® interface and is ready to be paired.
2. Next, set your Bluetooth ® mobile device to "discover" the wireless
headphones.
3. Place both devices not more than one meter away from each other.
4. On your mobile phone, tap the newly discovered audio device (Style-KWH-750)
being displayed in the Bluetooth list. The headset is now ready to be used
®
wirelessly.
5. If you have a lower Bluetooth version, you may be prompted to enter the
®
passkey 0000 (4 zeros).
6. If pairing is successful, the LED will glow blue. If after 60 seconds the pairing
process fails, please turn off the headset and repeat steps 1 through 5
described above.
7. The headset will enter into the Standby mode and will eventually turn off
automatically after five minutes if there is no matching device available for
pairing.
Note: The headset will automatically pair to the last known connected device 3
seconds after is powered on.