Hama Black Line Plus Instrucciones De Uso página 6

Note
• The range of the radio transmission between the
outdoor sensor and the base station is up to 50 m in
unobstructed areas.
• Before installation, ensure that wireless transmission
will not be disrupted by interference or obstacles like
buildings, trees, vehicles, high-voltage lines, etc.
• Before the nal installation, ensure that there is
su cient reception between the intended installation
locations.
• When assembling the outdoor sensor, take care to
ensure it is positioned so that it is protected from
direct sunlight and rain.
• The international standard height for measuring air
temperature is 1.25 m (4 ft) above ground.
Warning
• Buy special or suitable installation material from a
specialised dealer for wall-mounting.
• Ensure that no faulty or damaged parts are installed.
• Never apply force during installation. This could
damage the product.
• Before installation, ensure that the chosen wall is
suitable for the weight to be mounted, and make sure
that there are no electrical wires, water, gas or other
lines at the installation site on the wall.
• Do not mount the product above locations where
persons might linger.
5.1 Base station
• Use the base (I) to position the base station on a level
surface.
• Alternatively, you can install the base station on a wall
using the opening (J) on the back.
5
5.2 Outdoor sensor
• You can also set the outdoor sensor up on an even
surface outdoors.
• We recommend mounting the outdoor sensor securely
and rmly on an outdoor wall.
• Install an anchor, screw, nail, etc. in the wall of your
choice.
• Hang the outdoor sensor onto it using the cut-out
provided.
6. Operation
Note – Input
• Hold the button (B) or the
select the values faster.
6.1 Connection to the outdoor sensor
• After the batteries are inserted, the base station
automatically searches for a connection to the outdoor
sensor and carries out the initial setup routine.
Note
• Initial setup takes approximately 3 minutes.
• During the connection attempt, the radio signal on
the outdoor sensor (9) ashes.
• Do not press any buttons during setup. Otherwise,
values may not be transmitted correctly and there is a
risk of value errors and inaccuracies.
• The setup process is completed when the indoor
and outdoor measurement data (15/21/26/28) is
displayed.
• If no signal is received from the outdoor sensor on a
repeated basis, press and hold the
3 seconds to start the manual search for the signal.
button (C) to
key (E) for approx.