!
ATTENTION
Possible damage to property!
Never clean the device with aggressive solvents and cleaning agents, abrasive materials, spray water (garden
hose, high-pressure cleaner, etc.) or excessive pressure.
When installing the device, the following additional notes must be observed:
During outdoor installation, the connection panel cover must not be opened in unsuitable weather (rain, wind,
snow, etc.).
The device must be mounted on the wall vertically, without any tilt, on a completely flat wall or floor-mounted
column; the back side of the charging station must be completely protected.
The mounting holes may be drilled only by an authorized specialist in compliance with the safety regulations.
The supply line must not be damaged during this process.
When connecting and wiring the device, ensure that the connection area is clean so that no foreign objects
(pieces of wire, etc.) get inside the device.
The joints between the wall/floor-mounted column and the device must not be sealed with silicone. Water must
be able to drain off behind the device.
The device must not be used as a climbing aid.
General criteria for the site selection
Observe the permissible ambient conditions (see "Technical data" in the operating manual).
Take into account the local electrical installation regulations, fire prevention measures and accident prevention
regulations as well as emergency routes at this site.
The device must not be installed in zones at potential risk of explosion (EX environment); areas with special
hazards (flooding, mudslides, avalanches, etc.) must be avoided.
Do not install the device in the immediate vicinity of flammable materials.
The device may only be installed in stationary applications.
Install the device so that it is not in the direct path of people.
Do not install the device at locations where it is exposed to ammonia or ammonia gas (e.g. in or at stables).
The mounting surface must be sufficiently stable in order to withstand the mechanical forces.
Do not install the device at locations where falling objects could damage the device (e.g. hung-up ladders or
automobile tires).
The device must not be exposed to direct spray water (e.g. neighboring manual car wash facility, high-pressure
cleaner, garden hose).
If possible, the device should be installed with protection from direct rain and sunlight.
Follow the applicable national installation standards and regulations.
Disposal
ATTENTION!
Please observe the regulations regarding disposal of electric appliances and electronic devices.
EN
2