Philips AC4080-10 Manual Del Usuario página 14

Clean the pre-filter
and descale the
humidification filter
Filter alert light
status
Filter light / goes
on
Note
• Only the pre-filter and humidification
filter are washable. Filter 2 is not
washable.
• Filter light / goes on approximately
once every month (fig ƒ).
1
Wash the pre-filter under a running
tap. If the pre-filter is very dirty, use
a soft brush to brush away the dust
(fig „).
2
Air dry the pre-filter.
Note
Make sure that the pre-filter is
•
completely dry. If it is still wet, bacteria
may multiply in it and shorten the
lifetime of the pre-filter.
3
Mix the white vinegar with an equal
amount of tap water in a container
that is large enough to soak the
humidification filter in.
Note
White vinegar has 5% acetic acid.
•
If there are white deposits (limescale) on
•
the filter, make sure that the side with
the white deposits is immersed in the
water.
12 EN
Follow this
Clean the
pre-filter and
descale the
humidification
filter
4
Let the humidification filter soak in
the solution for one hour (fig ...).
5
Discard the water-vinegar solution.
6
Rinse the humidification filter
under the tap to rinse away vinegar
residues. During rinsing, turn the
humidification filter so that both
the front and back sides are rinsed
(fig €).
7
Let excess water drip off the
humidification filter and let it air dry.
8
After the pre-filter and
humidification filter are put back
in the appliance, reset the filter
lifetime counter. (Refer to chapter
7 "Resetting the filter lifetime
counter")