Graco Junior Maxi i-Size R129 Manual Del Propietário página 5

DO NOT use the seat if the surfaces are too hot from
sunlight.
Never leave the child unattended in the booster seat or
vehicle, not even for a few minutes.
Any luggage or other objects liable to cause injuries in the
event of a collision shall be properly secured.
The booster shall not be used without the soft goods.
The booster soft goods should not be replaced with any
other than the one recommended by the manufacturer,
because the soft goods constitutes an integral part of the
restraint performance.
Always secure child in booster, even on short trips, as this is
when most accidents occur. DO NOT leave this booster, or
other items unbelted or unsecured in your vehicle. Remove
the booster seat from the car if not regular used and store in
a dry, sun-protected surrounding.
It's recommended not to use a second-hand booster seat
whose history is not known. It may have invisible structural
damages or defects due to incorrect usage/storage.
DO NOT use any load bearing contact points other than
those described in the instructions and marked on the
booster.
DO NOT install this booster under the following conditions:
1. Vehicle seats facing sideways or rearward with respect to
the vehicle's direction of travel.
2. Vehicle seats movable during installation.
Consult the retailer for issues concerning maintenance
repair and part replacement.
To avoid burns, never put hot liquids in your booster's
cupholders.
7
Product Information
1. This is an i-Size booster seat Enhanced Child Restraint
System. It is approved according to UN Regulation
No.129/03, for use primarily in "i-Size seating positions" as
indicated by vehicle manufacturers in the vehicle user's
manual. If in doubt, consult either the Enhanced Child
Restraint System manufacturer or the retailer.
Product Booster seat
Materials
Plastics, Metal, Fabrics
Patent No.
Patents pending
Suitable for Child height 100cm-150cm (Reference age
3.5-12 years).
Installation Forward facing (in vehicle travel direction)
Booster Assembly
1 3
See images -
1
Squeeze the head support adjustment lever first and
then slide in lower back support under the fabric cover
to connect them together.
! CHECK to make sure two pieces are securely snapped
together by pulling on them.
2
To attach the lower back support to the base, hook the
lower back support over the seat bar hinge on the base.
3
Rotate the lower back support up while holding the
booster seat until it clicks into an upright position.
Height Adjustment – for
Head Support
4
See image
4
Squeeze the head support adjustment lever while
pulling up or down on the head support until it snaps
into one of the 10 positions.
8