Hitachi YUTAKI H Combi HWD-WE-220S Manual De Instrucciones página 14

UNIT INSTALLATION
3. Unscrew the 4 screws which fix the unit to the
wooden base.
!
CAUTION
Be careful with the Installation and Operation manual and with the
factory-supplied accessories box located at the top of the unit.
4. Remove the indoor unit from the wooden base and
place it carefully on the floor, as near as possible to
its final location.
EN
PMML0596 rev.0 - 04/2022
Wooden
base
Screws
!
CAUTION
• Four people are required when lifting because of the heavy
weight of the unit.
• Be specially careful with the mounting feet once the unit is on the
floor. Avoid harsh handling of the unit, as it could cause damages
to the foot.
• Each mounting feet can be adjusted up to 30 mm, but keep all
them in the factory-supplied position until the unit has been
installed in its final position.
5.1.3 Factory-supplied indoor unit components
Accessory Image Qty.
Shut-down
4
valve
Gasket 12
Instruction
1
manual
Packaging
- 1
instruction

NOTE
• The previous accessories are supplied inside the indoor unit, and
are accessible from top of the unit, once the carton cap has been
removed.
• Additional water piping (field supplied) for connections to
outdoor unit needs to be available.
• If some of these accessories are not packed with the unit or any
damage to the unit is detected, please contact your dealer.
Purpose
To make easier the
installation work in the
space heating water
inlet/outlet connections.
For a better servicing.
Two gaskets for each
space heating inlet/
outlet connections
and another two for
each DHW inlet/outlet
connections
Basic instructions for
the installation of the
device.
Material composition
identification &
consumer instructions
for separate waste
6