Publicidad
Idiomas disponibles
Idiomas disponibles
Your new tiller has been assembled at the factory with the exception of those parts left
unassembled
for shipping purposes. To ensure safe and proper operation of your tiller
all parts and hardware you assemble must be tightened securely.
Use the correct tools
as necessary to insure proper tightness.
TOOLS
REQUIRED
FOR
ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(1) Utility knife
(1) Wire cutter
(1) Tire pressure gauge
(1) Screwdriver
(1) Pair of pliers
(1) 9/16" wrench
4. Cut down right hand front and right
hand rear corners of carton, lay side
carton wall down.
5. Remove packing material from handle
assembly.
6. Separate shift rod from handle as-
sembly.
Shift Rod
OPERATOR'S
POSITION
When right or left hand is mentioned in
this manual, it means when you are in the
operating position (standing behind tiller
handles).
FRONT
LEFT
RIGHT
OPERATOWS
POSITION
UNPACKING
CARTON
_CAUTION:
Be careful of exposed sta-
ples when handling or disposing of carton-
ing material.
IMPORTANT: When unpacking and
assembling tiller, be careful of exposed
staples when handling or disposing of
cartoning material.
1. While holding handle assembly, cut cable
ties securing handle assembly to top
frame. Let handle assembly rest on tiller.
2. Remove top frame of carton.
3. Slowly ease handle assembly up and
place on top of carton.
Handle
Assembly
INSTALL
HANDLE
.
Insert one handle lock (with teeth fac-
ing outward) in gearcase notch. (Apply
grease on smooth side of handle lock
to aid in keeping lock in place until
handle assembly is lowered into po-
sition.)
VIEWED FROM R.H. SIDE OFTILLER
_.:e
../Ha.
Handle Assembly
arcase Notch
ndle Lock
2. Grasp handle assembly.
Hold in "up"
position.
Be sure handle lock remains
in gearcase notch. Slide handle as-
sembly into position.
3. Rotate handle assembly down. Insert
rear carriage bolt first, with head of
bolt on L.H. side of tiller and loosely as-
semble Iocknut.
6
Publicidad
