Speck pumpen BADU 42-AK Instrucciones Para El Manejo página 76

Installation
5.4 Electrical connection
W A R N IN G
Risk of electric shock due to incorrect connections!

Electrical connections must always be carried out by
authorised specialists.

Observe VDE and utility company regulations.

Install swimming pools and their protection according to
DIN VDE 0100-702.

Install a disconnecting device with at least a 3 mm contact
gap per pole to interrupt the power supply.
W A R N IN G
Risk of electric shock due to voltage on the housing!

A built-in or external overload switch which is set correctly
must be installed for pumps with three-phase or A.C. motors
without motor protection (see pump data sheet). In doing so,
observe the values on the motor name plate.

Protect power supply with a ground fault circuit interrupter,
nominal residual current I

Only use suitable pipe types according to regional
regulations.

Adjust minimum diameter of the pipes to accommodate the
motor output and pipe length.

If hazardous situations can occur, provide emergency off
switch according to DIN EN 809. The builder/operator must
make a decision according to this standard.

Connection by customer:
– Fuse protection 1-phase 230 V/3-phase 400 V safety fuse
16 A time delay or 16 A circuit breaker
Pos : 85 /T echnisc he Dokumentation/Allgemei ne Module/#### Sei tenumbruch #### @ 0\mod_1426069111812_0.doc x @ 891 @ @ 1
20 EN
≤ 30 mA.
FN
10|2015