Onkyo CP-1046F Manual De Instruccion página 4

tracking force scale [9]
rotate the scale ring
only
counterweight
We as
Now, slowly rotate the counterweight [8] in the direction
of the arrow (the scale ring will also rotate) until the
correct amount of tracking force for the cartridge in use is
applied.
rotate the
counterweight
After setting the appropriate amount of tracking force,
set the anti-skating knob to the same value. If this
is forgotten, the stylus may skid over the surface of the
record during record play.
Connections
Connect the output cord from the CP-1046F to the
PHONO terminals of your audio amplifier as shown
below. Connect the power cord to the socket on the
rear panel of the amplifier or the wall socket.
Power cord
Do not reverse left and right output cords.
Playing a Record
Always wipe records with a good cloth to remove dust
and other particles before placing the stylus in the
starting grooves. Also confirm that no dust is clinging
to the stylus. A dirty record and stylus can cause
unpleasant static during record play.
The CP-1046F is a fully automatic turntable. However,
manual and auto-repeat operation are also possible. Be
sure the unit has been set properly before beginning
record play. In particular, check the tracking force
setting and connections regularly.
Fully Automatic Operation
1. Place a record on the turntable mat [1] and set the
Speed Selector [22] to the correct speed for the
The speed switches between 33 and 45 each time
the Speed Selector [22] is pressed and the corres-
ponding indicator lights.
2. Set the Record Size Selector (2!] to the correct
setting for the record about to be played.
The record size setting switches between 30 cm
and 17 cm each time the Record Size Selector
is pressed and the corresponding indicator lights.
3. Press the Play/Reject Button [16] ; the turntable
platter [3) will begin to rotate, the Quartz Lock Indicator
will change from red to green when the platter speed
reaches the set speed and the tonearm [13] will automati-
cally move over to the record, lower into the starting
grooves and begin record play.
4. When the end of the record is reached, the tonearm
(13) will automatically return to the arm rest [12] , the
Quartz Lock Indicator will change into red and the
turntable platter [3] will stop rotating.
5. To interrupt record play before the end is reached,
depress the Play/Reject Button [!6| . The tonearm
13) will immediately return to the arm rest [12] and
the turntable platter [3] will stop rotating.
6. Do not touch or forcibly move the tonearm during
this time as it will damage the automatic mechanism.
Manual Operation
Fully automatic operation can only be used to play a
record from the beginning. To begin record play from
another location, it is necessary to operate the CP-1046F
manually.
Press the Cue Button [17] to the up position to raise the
tonearm {!3| off the arm rest. Now move the tonearm
over the record until the stylus is directly over the
section to be played; the turntable will automatically
begin rotating. Depress the Cue Button again to lower
the tonearm onto the record surface and begin record
play. The tonearm will automatically return to the arm
rest when the end of the record is reached or the Play/
Reject Button [16 is depressed.
Repeat Function
To operate the repeat function, simply depress the
Repeat Button |19}). The REPEAT indicator will
light up and the record will be played again and again.
The repeat function is cancelled by depressing the
Play/Reject Button [16} to stop record play immediately,
or by depressing the Repeat Button [19] once more, in
which case the record will be played to its end. In
either case, the REPEAT indicator will turn off.